How can you differentiate two IDE drives on the same cable?
To allow for two drives on the same cable, IDE uses a special configuration called master and slave. This configuration allows one drive’s controller to tell the other drive when it can transfer data to or from the computer.
Is IDE ribbon cable hard drive connector?
The two most common types of IDE ribbon cables are the 34-pin cable used for floppy drives and the 40-pin cable for hard drives and optical drives.
What is the difference between a SATA and IDE hard drive?
IDE is an interface standard for connection of storages devices such as Hard Disk Drives (HDD), Solid State Drives (SSD) and CD/DVD drives to the computer. SATA is a computer bus interface or standard hardware interface which connects connecting hard drives, Solid State Drives (SSD) and CD/DVD drives to the computer.
What is the purpose of the jumpers on an IDE hard drive?
Hard Drive Selection Jumpers are used on IDE/ATA hard drives to select their operation mode, and schematics like this one are commonly found on the drive to show how to place the jumper on the pins. In “Single” mode, the jumper is not used.
What is IDE cable used for?
Integrated Drive Electronics (IDE) is a standard interface for connecting a motherboard to storage devices such as hard drives and CD-ROM/DVD drives. The original IDE had a 16-bit interface that connected two devices to a single-ribbon cable.
Can a hard drive and CD ROM be connected on the same IDE cable?
Yes you can connect a harddrive and a cd-rom on the same IDE cable. Just set one master and one slave. As for on which pin to place the jumper.. That’ll be on the sticker that’s usually on the harddisk and cdrom..
Can a CD drive be connected to an IDE controller?
Now that you know what an IDE controller looks like, let’s look at the process of connecting the CD drive to the IDE controller. To make the connection, you’ll use an IDE cable. An IDE cable will connect the CD drive to the system’s IDE controller. There are only two types of IDE cables: single-device cables and daisy-chain cables.
What kind of cable do I need to connect a CD drive?
To make the connection, you’ll use an IDE cable. An IDE cable will connect the CD drive to the system’s IDE controller. There are only two types of IDE cables: single-device cables and daisy-chain cables. You can use a daisy-chain cable even if you’re working with a single device.
Where do I plug the IDE cable into?
Now you’re ready to plug the IDE cable into the CD drive. The CD drive contains three ports for connecting cables: the IDE port, the power port, and the audio port.