How big is the rear axle on a 5500?
Brake job ’06 5500 13.5klb rear axle. I am doing the brakes on my ’06 5500. I have noticed that there is no information on doing the brakes on these big ol trucks so I figured I would do a walk threw. I have spent most of the day looking at stuff going ” huh” and searching the internet trying to find information and coming up empty handed.
How do you get an axle shaft out of a 2005 F350?
There should be a smilie for turning a blind eye.) Take a medium sized pry bar and slide it in behind A. With the steering knuckle straight carefully pry it out. It will push the vacuum seal that is stuck in the hub out without damaging it. I have done this hundreds of times over the years.
How to remove a wheel bearing and hub?
How To Remove A Wheel Bearing And Hub In Under 1 Min! – YouTube How To Remove A Wheel Bearing And Hub In Under 1 Min! If playback doesn’t begin shortly, try restarting your device.
Can you remove the wheels from a BMW 5500?
Remove the wheels, our wheels are hub piloted so you will have to rock them a bit to get them past the pilot pads then they will just slip right off. at that point this is that you will be looking at. it would be advised that you grab a dish or small bucket to catch the small amount of gear oil that will be coming out in the next step.
What to do when you replace rear wheel seal?
After the nuts are out go ahead and remove the rotor. and slap it back together. I also replaced the rear wheel seal just for G.P. again when you replace the hub assembly on the spindle be carefull to not damage the rear wheel seal or you will leak gear oil all over the inside of your wheels and your brakes.
How big is the brake job on a 06 5500?
My 07 5500, has a body that weighs 7,000 pounds ( empty) My fronty pads are brand new, and my rear pads are more than half worn in 18,000 miles. Both the 06-07 are used it constant stop and go service (garbage and recycling).