How are the wires on a throttle actuator identified?

How are the wires on a throttle actuator identified?

But, before going into the short process of identifying the 2 wires for the motor without a wiring diagram, we should mention the following. Identifying the motor wires is fairly straightforward, but identifying the dual or triple T P S wires is not. Electronic throttle actuators have 2 or 3 internal throttle position sensors.

What are the connectors for an ebike throttle?

If you are new to ebikes? the first time you see this, it can give you a huge headache. For those ebikers just starting out, this article will cover connectors for the three phase wires for the motor, the hall-sensors, the throttle…plus, the ignition wire (either hot-wired, or attached to an on/off switch).

How to repair a wiring harness and throttle position sensor?

Plug in the wiring harness connector if you are not going to change it. Cut the wires on the pigtail about 1 inch away from where they enter the main wiring harness. Strip about 1/2 inch of the insulation off the wires at the main wiring harness connector. Insert each one of the bare wires into a separate butt connector.

What should the resistance of a throttle wire be?

The main point to remember, is that when identifying the electronic throttle motor wires or terminals, the resistance will be below 10 Ohms. So expect very low resistance. Here we can see what you should see when the motor wires are tested with the Ohm meter.

How to remove throttle by wire plug Road 6 customs?

Remove one wire at a time, moving the tool to the next wire one by one. When you are ready to put it back together simple put the wires back in where they came out and push the white cap back down to lock them in place. You’re done!

If you are new to ebikes? the first time you see this, it can give you a huge headache. For those ebikers just starting out, this article will cover connectors for the three phase wires for the motor, the hall-sensors, the throttle…plus, the ignition wire (either hot-wired, or attached to an on/off switch).

Plug in the wiring harness connector if you are not going to change it. Cut the wires on the pigtail about 1 inch away from where they enter the main wiring harness. Strip about 1/2 inch of the insulation off the wires at the main wiring harness connector. Insert each one of the bare wires into a separate butt connector.

But, before going into the short process of identifying the 2 wires for the motor without a wiring diagram, we should mention the following. Identifying the motor wires is fairly straightforward, but identifying the dual or triple T P S wires is not. Electronic throttle actuators have 2 or 3 internal throttle position sensors.

Posted In Q&A