Does the steering wheel lock on a Jeep JK?
Jeep has phased out manual steering locking mechanisms since 2009. This is effective across all models of Jeeps and can be seen in the Case Number as taken from the Chrysler/dodge/jeep technician helpline.
Why is my door lock not working on my Jeep Wrangler?
Door locks will not lock using fob or rocker switch / windshield washer will not work/ heater will not work/ radio dims when headlights are turned on/ dome light will not turn on upon opening door. See all problems of the 2012 Jeep Wrangler .
Why does my Jeep Wrangler remote not work?
The contact owns a 2007 Jeep Wrangler. The contact stated that the remote door lock would not operate. Upon inspection, it was discovered that the fuse to the doors had blown. The fuse was replaced but, moments later, had blown a second time.
What makes the steering wheel lock on a Jeep Wrangler?
Your vehicle may be equipped with a passive steering wheel lock (manual transmission only). This lock prevents steering the vehicle without the ignition key. If the steering wheel is moved a half turn in either direction and the key is not in the ignition, the steering wheel will lock.
Why are my power door locks not working?
Jeep Wrangler owners have reported 3 problems related to power door locks not working (under the electrical system category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Jeep Wrangler based on all problems reported for the Wrangler.
How can I unlock my Jeep with remote key?
I park the truck to get out. I put it in “Park”, turn off the truck, remove the key, open the door, get out of the truck, close the door et then I try to lock the doors using my remote key but nothing happens. I can try 1, 2, 3 or 10 times to lock/unlock, nothing happens at all.
Where is the locking mechanism on a Jeep Wrangler?
The steering wheel locking mechanism is located on the steering column and functions very similar to a regular door lock assembly. It consists of a plate located on the bottom of the assembly that the key mechanism inserts/slides into. There is a spring located directly underneath the plate that engages while the engine is switched off and in park.
What to do if your Jeep Wrangler steering wont lock?
Remove the steering coupler bolt and column mounting nuts and lower column. Remove column. Remove switches and clock spring. We’ve identified the device known as the Key Lock assembly to be the faulty component when your Jeep Wrangler fails to lock its steering.
Is there a problem with my Jeep Wrangler?
My problem is known to Jeep. They are looking into it. They have the same issue with the Caliber and the Wrangler. Some people are, like me, unable to lock the doors until they put the key back in the ignition then remove it again then are able to lock the doors.