Do you need to reset service reminder on Volvo S60?
Please try again later. After changing oil and filters in your Volvo S60, V70, XC70, S80 or XC90 you can reset service reminder yourself. You don’t need diagnostic interface or expensive computer to do so. All you need to do is perform reset procedure and your Volvos maintenance reminder will be cleared.
How do you reset the trip meter on a Volvo S60?
Step 1. Confirm that you have the trip computer in T-1 mode; Step 2. Put the car key, and turn the ignition to position I ; Step 3. Press and hold trip meter reset button until the trip meter reads “0.0”. Do not release trip meter reset button; Step 4.
How do you reset the Trip Reset button on a Volvo?
Press and hold trip reset or T1/T2 button on the instrument cluster. If you have digital instrument cluster, press and hold OK button on the left stalk. Turn key into II position while still holding the trip reset button. Press if you have START/STOP button. Wait until yellow indicator starts to blink. This takes about 10 seconds.
How long does the service reminder message last?
The service reminder indicator (SRI) informs the driver that it is time for the car to be serviced. The text message is displayed for 120 s each time the ignition is switched on. -Ignition position II.
What kind of car is the Volvo S60?
The Swedish automobile manufacturer plans to launch the latest version of the Volvo S60 sedan Cross Country, which is a crossover sedan. Volvo S60 wants to introduce to the wider public at the Detroit Motor Show next week, which will be joined by other models in the segment such as the Volvo V40 Cross Country hatchback, and the Volvo V60 estate.
Is there a way to reset the service light?
If you’ve done the maintenance work and now want to reset the light, follow these instructions: Step 1. Confirm that you have the trip computer in T-1 mode; Step 2. Put the car key, and turn the ignition to position I ; Step 3. Press and hold trip meter reset button until the trip meter reads “0.0”. Do not release trip meter reset button; Step 4.
What happens when you reset your Volvo computer?
Once I reset the computer, it instantly had its pep back.” The 628 was allegedly stock for the 1995 T5-R, 1996 850R and 1997 850R. I have a list of part numbers for the T5-R ECU’s, and one of the 850R ECU’s, all from the EGR delete attachment (which is interesting in itself!)
Can You disconnect the ECU on a Volvo?
Since all 1990s and 2000s Volvos’ ECU’s have volatile memory and rely on a constant supply of 12 volts DC from the car, disconnecting the battery will do it. Follow the link below for more on this procedure.
Where is the alarm system required on a Volvo S60?
When faced with the “Alarm System Service Required” message on the dashboard of a 2000+ Volvo S60, S80, or V70, the problem is almost always the siren module, a device located behind the front bumper cover on the on the passenger side of the vehicle, just behind the wheel well.
Why is my alarm not working on my Volvo?
If the alarm module doesn’t provide the ground to start relay then the relay doesn’t provide feed to starter solenoid and no cranking results. Usually locking the car and then unlocking it should reset the alarm. The alarm module is also the door lock, fuel cap unlock, trunk lid latch, and interior light module.
How to replace the siren module on a Volvo?
How To Replace The Siren Module. Begin by removing the inner fender liner to gain access to the siren. Turn the front wheels all the way to the right or jack up the front of the vehicle and remove the passenger front wheel for easier access. Drill out the rivets from the front edge of the plastic inner fender liner.