Do you need to replace the water pump on a Toyota Camry?
Although many dealerships and private service stations recommend replacing the water pump along with the timing belt, the Aisin brand water pumps used in Toyotas are actually very durable.
What kind of timing belt does a Toyota Camry have?
This motor is commonly found in the Camry, Celica, MR2 and RAV4 from 1990 to 2001. (For a six-cylinder Camry, see my article on MZFE timing belt replacement ).
What causes oil leak in Toyota Camry 5sFE?
Oil leaks from the vicinity of the passenger-side front wheel may indicate a need to replace the timing belt and seals. The 5SFE is a “non-interference” engine, meaning that if the belt breaks while the car is running, the valves and pistons are unlikely to be damaged.
What kind of engine does a Toyota Camry have?
The Toyota 5SFE motor is a four-cylinder, 2.2 liter, timing-belt-driven, double overhead cam (DOHC) engine design. This motor is commonly found in the Camry, Celica, MR2 and RAV4 from 1990 to 2001. (For a six-cylinder Camry, see my article on MZFE timing belt replacement). 5SFE timing belt diagram
How to replace a timing belt on a Toyota Camry?
Therefore, you can use the instructions below to replace a broken timing belt on a non-VVTI engine. Positioning the camshaft sprockets and the crankshaft pulley alignment marks to Top Dead Center (TDC) is all you need to do before installing the new belt.
How long does it take to replace timing belt and water pump?
Expect to spend approximately three hours replacing the timing belt, guide pulley, and tensioner pulley alone. Replacing the water pump adds about a half hour, and replacing sprocket seals adds about a half hour per seal.
When to replace the seals on a Camry 5sFE engine?
On 5SFE engines with over 100,000 miles, there is a good possibility that the seals on the camshaft, crankshaft and oil pump will be worn. These seals are inexpensive, though time-consuming to replace.
How much does it cost to replace a water pump in a Toyota?
Toyota Dealership wants $580 to replace the water pump and coolant (no flush, just drain). Local brake/muffler shop wants approx. $300 to replace pump and fluids (again no flush, just drain). Local Toyota Dealership parts department sells the water pump for $121.50 and a gallon of fluid for $23.99.
Why is my water pump leaking on my Toyota Corolla?
Have a 2005 Corolla LE with only 63,000 miles on it that both the Toyota Dealership and a local brake/muffler shop have indicated the water pump is leaking (possibly from the water pump weep hole). Toyota Dealership wants $580 to replace the water pump and coolant (no flush, just drain).
Where is the drain plug on a Toyota Camry?
Remove the drain plug from the bottom of the radiator on the passenger side. Replace the plug when finished. You will also want to drain it from the engine block as well by removing the two drain plugs on the bottom front and rear of the engine. The rear is a little more difficult to get to.
How do you remove a power steering hose?
1. Remove power steering hose held by hose clamp 2. Remove 17 or 19 mm bolt. Make sure not to lose (2) copper o rings 3. Remove power steering sensor wire 4. Remove top and bottom 14 mm bolt. Remove drive belt Loading…
What kind of parts does a Toyota Camry use?
If you want to use Japanese OEM (Original Equipment Manufacturer) parts–the parts that Toyota puts its own label on–you will want a Mitsuboshi timing belt, Koyo pulleys, and an Aisin water pump. Other Japanese OEM brands include Denso, NGK, KYB, Akebono, GMB, and Sumoto.
How long does it take to replace timing belt on Toyota Camry?
Expect to spend approximately three hours replacing the timing belt, guide pulley, and tensioner pulley alone. Replacing the water pump adds about a half hour, and replacing sprocket seals adds about a half hour per seal. 1/2-Inch breaker bar (if no impact driver available) 1/2 & 3/8 socket wrenches, box wrenches and sockets
What kind of parts do you need for a Toyota Camry?
If you want to use Japanese OEM (Original Equipment Manufacturer) parts–the parts that Toyota puts its own label on–you will want a Mitsuboshi timing belt, Koyo pulleys, and an Aisin water pump. Other Japanese OEM brands include Denso, NGK, KYB, Akebono, GMB, and Sumoto. But you can find good parts from other manufacturers as well.
What do you need to replace timing belt on Toyota Camry?
Some things to note on the 1MZFE engine are: A 10mm stud holds the water pump to the block on this engine. A stud removal tool can be used, otherwise the camshaft sprockets and timing belt cover will need to be removed first. The tensioner will apply tension to the belt as the tesnioner bolts are tightened.