Can you weld a stator cover?
Yes it can be welded.
What is a stator cover on a motorcycle?
A motorcycle stator is a component of the electrical system that, when combined with a rotating magnet, creates AC current. Stators are inside the engine case. An automotive style alternator is a fully self-contained, externally mounted unit that creates DC current.
What makes a stator go bad on motorcycle?
To answer why stators fail, it is because the coating on the windings breaks down, usually because of heat, causing a short which can also burn the fine wire of the winding in two at the short causing an open circuit. The way to prevent failures is to prevent the heat.
Can you JB Weld a crankcase?
Tracking down a new crankcase costs time, and it’s often an expensive part to replace. But there is a product that will do all three things perfectly: JB Weld Original Cold Weld Formula Reinforced Epoxy.
What to do if you have a bad stator?
Without a good stator, your engine will run poorly or not at all. This solution completely bypasses the stator by using a 12 volt battery to power the ignition system. Everything required can be purchased for under $50. It will work on all contact breaker point engines (old style), and some electronic controlled ignition (newer style) ones.
How do you remove a nut from a stator?
1- To remove the nut, the flywheel must be locked in place or else it will simply turn. You can lock it in place by using a special tool. Alternatively, you can lock it this way: remove the spark plug and feed wire or rope down into the cylinder.
How is a stator attached to an engine?
First the easy: attaching the negative (black) wire going to the engine. This wire can be attached to any conductive part of the engine assembly. On cars and motorcycles the metal parts of the engine are in electrical contact with each other, which causes them to make up one large electric terminal.
What do you need to Rectifi a Yamaha Ho stator?
HW Yamaha Rhino HO Stator Rectifier Instructions Tools Needed: 10mm socket 8mm socket 10mm wrench 17mm socket Ratchet Philips head screw driver Vise-Grips 1. Remove seats, engine cover and center floorboard section. 2. Removing the dump bed is optional but makes it easier. 3. Drain engine oil and engine coolant. 4.