Can you reset engine codes?
Some vehicles will automatically reset the trouble codes that caused the initial error after the vehicle is turned on and off three times in succession. To do this, insert your key into the ignition, turn the vehicle on for about a second, and then off for about a second.
Where to find fault codes on Mercedes P2004?
Location of OBD II port used to retrieve Mercedes-Benz fault codes. Turn key to position II, do not start the engine. Press read codes button. After the codes are displayed you can erase them by pressing the erase button on your scanner. If playback doesn’t begin shortly, try restarting your device.
How do you delete error codes on Mercedes Benz?
Push right AUTO button and see if there are any errors (like b1416 on the left). If there aren’t any it should display FF (in deutsch – Fahler Frei (No Errors)). You can search through the list by pressing the AUTO buttons. You can ALSO DELETE ERRORS by PRESSING SIMULTANEOUSLY BOTH AUTO buttons.
How to reset the computer code on a Mercedes C class?
Turn the ignition switch to “ON.” Press the power button on the scan tool, if it does not come on automatically. Wait for the tool to complete the scanning process. Press the “Reset” or “Erase” button on the scan tool to reset the computer codes. “Mercedes-Benz C-Class Operator’s Manual”; Mercedes-Benz USA, LLC; 2010
How to reset the Mercedes Benz ESP warning light?
Replacing the ABS sensor is easy, you can learn how to replace ABS sensor here. Note that once you will replace the ABS sensor and will still have the ESP warning light on. You will need to follow the procedures below to reset the light.
How do you reset a Mercedes Fault code?
Plug in an OBD2 scanner and reset the code. Carsoft makes one that works with the 38 pin connector or you can get software/cable from OBD-2.com that uses the 16 pin connector under the dash. Alternatively, you can disconnect your battery for 30 min or so and it should reset the codes.
Location of OBD II port used to retrieve Mercedes-Benz fault codes. Turn key to position II, do not start the engine. Press read codes button. After the codes are displayed you can erase them by pressing the erase button on your scanner. If playback doesn’t begin shortly, try restarting your device.
How do I clear a Mercedes check engine light?
If you would rather clear the codes then use an OBD II code reader to clear the check engine light by following these steps. Plug the code reader in the OBD II port under the dash. Location of OBD II port used to retrieve Mercedes-Benz fault codes. Turn key to position II, do not start the engine. Press read codes button.
Replacing the ABS sensor is easy, you can learn how to replace ABS sensor here. Note that once you will replace the ABS sensor and will still have the ESP warning light on. You will need to follow the procedures below to reset the light.