Can you replace AC compressor pulley?
If the AC compressor on your classic car has stopped working and you would rather not replace it, installing an AC compressor bypass pulley is a viable option for safely and efficiently removing your factory AC compressor.
How do I know if my condenser is bad?
If your AC condenser is about to experience failure, you may notice one of the following warning signs:
- Loud and abnormal noises coming from the unit.
- Significantly reduced cooling capability from the unit.
- The unit is leaking a noticeable amount of fluid past the typical amount of condensation.
Why is my air con not working in my Hilux DC 4×4?
when the system works hard, the high pressure goes up and up, then the fan is supposed to come on. If not, there may be a safety switch cutting out the ac when the pressure gets too high …. but it could be a number of other stuff as well. Vehicle: ’90 SFA Hilux DC 4X4, Full OME, 110mm lift.
How to install rear axle bearing on Toyota 4×4?
Install new oil seal. Remove inner axle oil seal. Clean surfaces and install new inner axle oil seal being carefull not to damage the new seal. Before installing the rear axle shaft into the backing plate apply MP grease to the oil seal. Insert the backing plate and bearing retainer on the rear axle shaft.
What causes half shaft to leak in Toyota 4×4?
Incorrect fitment and positioning of the retainer collars and inner seals can also cause the half shaft to leak by not setting the correct depth or fitting the seal squarely into the axle casing. Please follow our fitment guide for correct procedure which WILL stop your rear axle leaking if followed correctly.
What kind of exhaust does a Hilux DC 4×4 have?
Vehicle: ’90 SFA Hilux DC 4X4, Full OME, 110mm lift. Brospeed branch, 50mm ss freeflow exhaust. 30 x 9.5 Discoverer S/T’s on Viper mags.