Can a Toyota smog check readiness monitor not be set?
If there are pending malfunctions that have not yet turned on the malfunction light, the monitors will not become ready. In this case, you must continue the drive cycles until the malfunction shows up.
What do you need to know about inorder to pass inspection?
Inorder to pass inspection your car needs to complete a full drive cycle so that all (8) internal monitors have a status of “Ready”. If any of the (8) monitors have a status of “Incomplete” that means you have not yet completed a full drive cycle and you need to drive your car around more.
Where can I get a readiness monitor for my car?
It’s helpful to have your own scan tool to know the status of the readiness monitors. If you don’t have one and don’t want to buy one, some auto parts stores will rent them to you. Some auto parts stores like AutoZone will scan the codes and check your monitors free of charge.
Why did my car not pass the inspection?
If the Oxygen Sensors are out of whack that could possibly trick the engine control module into thinking that there is a problem with the catalytic converter. So that was ruled out.
What happens when your car fails a smog test?
When your car gets a smog test, one portion of the test involves connecting the smog test machine to the car’s computer and checking if there are any DTC’s, and also checking to see if the monitors are ready. If they are not, the vehicle fails the test, because there may be problems in the system that can’t be reported by the computer.
Can a car pass with only one smog monitor?
Note that a car can pass with some incomplete monitors…a maximum of one on 1999 and earlier cars, and only one ( The Evaporative System monitor) on model year 2000 and later gasoline powered automobiles. All monitors must be complete on 1998-2006 diesel powered vehicles.
Can a DTC erase a smog check monitor?
If your car has recently been repaired for a problem that set a DTC (check engine on) and the technician cleared the DTC, he also erased the monitors. Also, if battery has been disconnected, replaced or needed a jump-start, the monitors may be erased.
What’s the drive cycle for a Toyota Camry?
The EVAP Monitor is not required to be complete (Ready) in order to pass the California smog check. According to my software the EVAP monitor drive cycle for a 2001 Toyota Camry is to: Drive at 45 mph for 5 minutes (steady) then decelerate to 25 mph for 15 minutes then back to idle.
How long does it take to set a smog monitor?
Drive at highway speed 55-60 mph with steady throttle for 16 minutes. Return to idle for three minutes with engine running in park. Drive again at medium speed 40 mph for eight minutes. Return to idle for three minutes. Repeat next day. One monitor requires a minimum temperature of 40 °F.
What is the EVAP drive cycle for a Toyota Camry?
According to my software the EVAP monitor drive cycle for a 2001 Toyota Camry is to: Drive at 45 mph for 5 minutes (steady) then decelerate to 25 mph for 15 minutes then back to idle. Catalyst monitor drive cycle for 2005 Toyota rav4? 2005 Toyota Rav 4 catalyst monitor drive cycle is usually relatively simple.
When does the readiness monitor complete on a Toyota Camry?
Although the drive cycle for a 2003 Toyota Camry might be slightly different, it’s worth giving it a try. As long as all the emission systems are working correctly, the readiness monitors should complete without setting a fault code (DTC) by the end of the drive cycle. 2004 Toyota Solara 2.4L 4 cyl engine. Drive Cycle for Evap, Catalyst ?