Can a Mitsubishi L200 engine be reconditioned?
Click Here! I purchased a less used Mitsubishi L200 and I was surprised to see how clean it was. When I uncapped the oil pan, I could easily see it was Read More I am happy with my Mitsubishi L200 reconditioned engine sent from these guys. The price was also reasonable. Keep up the good work.
Is the engine management light on on a L200?
I have a L200 the engine management light has come on . I have a L200 the engine management light has come on . Hi I have a L200 the engine management light has come on . There is a lose of power also the engine cuts out but if you swith off it will then start again.
How often should timing belt be replaced on Mitsubishi L200?
How many miles do you have on this engine ,has the timing belt been replaced ,this should be done every 60.000 miles. Customer: replied 6 years ago. The exhaust does not smoke when driven. The smoke is clear after starting. The starter is not slower when hot. The mileage is 79,000 and the timing belt has not been replaced at 60,000.
What’s the problem with my Mitsubishi L200 Animal?
I have a 56 plate l200 Animal, at 56000 miles i started having over heating problems.The thermostat would rise into the red and them blow water out of the header tank. After many atemps to find what the probem was they finally found that there was a problem with the head.
What kind of engine does a Mitsubishi L200 have?
I have a mitsubishi l200 4life 2.5 turbo pick-up 2004,recently I have had some overheating problems,mainly bubbling in the header-tank.
What causes a 2005 Warrior L200 to overheat?
I Have 2005 Warrior l200 it started overheating pulled it down found gasket to be problem which was causing bubbling in expantion tank You can’t post conmments that contain an email address. An expert who has achieved level 1.
What to do if your Mitsubishi L200 overheats?
Initially replaced thermostat, bled & topped up coolant system all ok for a week or 2, Problem reoccured with slight bubbling in header tank, I replaced thermostat a 2nd time, which I found to be closed on inspection. Repeated the process again and still slight bubbling.