Can a GMC Yukon have low oil pressure?
If it’s the Oil Pressure Sensor, no, it’s not that bad. The sensor isn’t expensive, and it’s a fairly quick replacement procedure, so labor shouldn’t be that bad. If the actual oil pressure test shows that it IS really low, then the cost is going to rise.
Where is the oil pressure sensor on a Yukon Denali?
The sensor is located on the top, rear, driver’s side of the engine, and requires a special tool to remove. Inspect the electrical connector for any loose or oil-soaked wires.
How much does a GMC Yukon oil pump cost?
Unfortunately- HUGE. The Bearings sell for around $75 for the set, and the labor time guide calls for 21.2 hours to complete the job. The oil pump sells for around $137 and there should be no extra labor, as this will need to be removed to gain access to the bearings.
How much does a GMC Yukon Denali cost?
As for the labor- at a non-Dealer shop, a “fair” labor rate can be anywhere from $75-$125 per hour (I’m out here on the East Coast, and we’re a non-Dealer shop, and we’re getting $85/hr). Just wanted to let you know, so that you wouldn’t be surprised.
If it’s the Oil Pressure Sensor, no, it’s not that bad. The sensor isn’t expensive, and it’s a fairly quick replacement procedure, so labor shouldn’t be that bad. If the actual oil pressure test shows that it IS really low, then the cost is going to rise.
The sensor is located on the top, rear, driver’s side of the engine, and requires a special tool to remove. Inspect the electrical connector for any loose or oil-soaked wires.
How long does GMC engine have to be off to check oil level?
If unable to wait two hours, the engine must be off for at least 15 minutes if the engine is warm, or at least 30 minutes if the engine is not warm. Always consult your GMC vehicle Owner’s Manual for the proper procedure to check your oil level.
How to check your oil and oil selection?
In order to get an accurate reading, engine must be off and vehicle on level ground. Accuracy improves when checking a cold engine (off for two hours) prior to starting. If unable to wait two hours, the engine must be off for at least 15 minutes if the engine is warm, or at least 30 minutes if the engine is not warm.
Why does my GMC Sierra have a low oil pressure light?
If your Sierra’s sensor has gone bad, it’ll shoot a false low pressure reading to the ECM. One of the first things that people do when they have the low oil pressure light is to change out this sensor to see if that rectifies the problem. Here’s a good article on how to check the oil pressure sensor from itstillruns.
Unfortunately- HUGE. The Bearings sell for around $75 for the set, and the labor time guide calls for 21.2 hours to complete the job. The oil pump sells for around $137 and there should be no extra labor, as this will need to be removed to gain access to the bearings.
When was the GMC Yukon XL last serviced?
1st owner drove an estimated 17,086 miles/year • 2nd owner drove an estimated 1,883 miles/year • 3rd owner drove an estimated 16,019 miles/year. Last serviced at 138,647 miles in Mountain Home, ID on 09/03/20 • Vehicle serviced.