Can a 2001 Subaru Outback engine be replaced?
I have two 2001s with engine problems. One with ~200,000 miles needs head gaskets, but the indie shop here in Central VA is telling me that because it’s a 3.0 engine, the entire engine needs to be replaced. The other (a 2.5), with ~150,000 miles has a hole in the engine block, and won’t hold oil.
Are there any problems with the Subaru Legacy?
Keeping in line with the recall we mentioned earlier, the 2008 Subaru Impreza mostly had issues with leaking head gaskets. The Subaru Legacy was not overly encumbered by problems with the engine throughout its life. The most problematic year for the Subaru Legacy’s engine was 2015.
Are there any issues with the Subaru Outback?
The 2013 Subaru Outback was the worst model year in terms of engine issues. Just like the Forester, the Outback suffered issues with the excessive oil consumption. Subaru exacerbated this problem for many drivers by essentially ignoring it and saying it was part of the normal operating procedure for the vehicle.
How much horsepower does a Subaru Outback have?
Its output is 130 horsepower at 5,800 rpm and 140 pounds per square foot of torque at 4,800 rpm. There’s also a 2.5-liter engine, the EJ25, with slightly more horsepower and torque than the EJ22. 3.0 – 3.6 L – During your search for low-cost Subaru Outback engines, you may run across a Subaru H6 motor for sale.
Do you need head gaskets replaced on a Subaru Outback?
Enter HERE for your chance to win a $400 Walmart gift card. I have two 2001s with engine problems. One with ~200,000 miles needs head gaskets, but the indie shop here in Central VA is telling me that because it’s a 3.0 engine, the entire engine needs to be replaced.
How much does it cost to replace a Subaru engine?
Car-part.com for engines. This cost me about $1200 including some additional repairs. The 2.5 is the easier one to start with. I have two 2001s with engine problems. One with ~200,000 miles needs head gaskets, but the indie shop here in Central VA is telling me that because it’s a 3.0 engine, the entire engine needs to be replaced.
When does a Subaru boxer engine start to have problems?
Consumer Reports says the older Subaru models using this engine will typically start to have head gasket issues around 90,000 to 150,000 miles. The reason the Boxer engine seems to be more prone to have this problem is because of the engine design.
How long does it take to replace a head gasket on a Subaru Outback?
You would have to remove the engine for that job, but you normally do that with a head gasket job on any Subaru engine- not just the 3.0. Pop it out, take it apart, clean it up and resurface it, reassemble, reinstall. Labor-wise you can usually do an engine removal and replacement in less than 10 hours.
How long does it take to replace a Subaru engine?
Labor-wise you can usually do an engine removal and replacement in less than 10 hours. If you actually do work to the engine while it is out, that would be more. If you’re just popping it out to throw it away and plug in another, there you go. It’s steep money.