Are there fuses still being made for AC circuits?
These and other fuses are still being manufactured for many applications, including for AC circuits and DC uses. Some are time delayed, slow reacting, or have leads for terminals used in circuits without a fuse holder. Many of the fuse dimensions and characteristics are published by the Society of Automotive Engineers as Standard SAE J 554.
What kind of Fuse does a Bussmann ATC use?
Bussmann makes the ATC that also complies with the same ISO 8820-3 and SAE J1284 standards. Maxi (APX), heavy-duty. Blade type fuses can be mounted in:
What are the different types of fuses for cars?
Blade type fuses come in six physical sizes: micro2, micro3, low-profile mini, mini, regular, and maxi. Blade fuses (also called spade or plug-in fuses), with a plastic body and two prongs that fit into sockets, are mostly used in automobiles.
Can a mini fuse be used as a blade fuse?
Where space permits, a miniature circuit breaker is sometimes used to replace a blade-type fuse in the same fuse holder. Blade fuses use a common coloring scheme for the Micro2, Micro3, low-profile (LP) Mini, Mini, and regular size fuses, and a partial color similarity with the maxi size fuses.
Where are the fuses located on a Porsche 911?
Ground point (G407) for DME components Table c through Table g list fuse positions in the front fuse/relay panel located in the left side of the luggage compartment and the rear fuse/relay panel located in the engine compartment. Fuse designations and locations are subject to change and may vary from car to car, depending on options.
How to troubleshoot a Porsche 911 blower motor problem?
In the case of the rear blower motor, the switch is connected to the red handles on the floor of the car. Check the switch with a continuity tester to make sure that it is working properly. Finally, if all the other tests fail to locate the problem, the wiring may be at fault.
Where is the high voltage potential on a Porsche 911?
At the top of the page (high voltage potential) it is similar to the top of the cliff, right before the waterfalls off the edge. Each path that the current diagram shows can be interpreted as a separate waterfall that turns a small turbine and generator as it falls down into the lake.