Are there any problems with the brake light on Mazda CX9?
Mazda CX9 owners have reported 5 problems related to brake light on (under the service brakes category). The most recently reported issues are listed below. I wanted to say it happened to us while we were driving back from a daytrip on Saturday.
What happens when the brake light is not replaced?
When not replaced, stop light will run continually or not function, potentially causing premature bulb failure, safety issues and/or the transmission will not shift out of park. A failed stoplight switch will prevent the brake light from illuminating when the brake pedal is applied that may cause a collision and a life lost.
When did the Mazda CX-9 fuse box come out?
Mazda CX-9 (2007 – 2010) – fuse box diagram Posted on 26 April 201729 July 2019by admin Mazda CX-9 (2007 – 2010) – fuse box diagram Year of production: 2007, 2008, 2009, 2010 Fuse block (Engine compartment) Mazda CX-9 – fuse box – engine compartment Position Description Fuse rating [A] Protected component 1 MAIN 150 For protection of all circuits
What to do if your brake light does not work?
Press down on the brake pedal and see if the lights illuminate. Note: On the newer style switch, you will not need to adjust anything and the lights should work after installation. If the lights do not work even after adjustment, a certified technician would be able to inspect the switch and diagnose the problem.
Why are the brake lights not working but the tail lights are?
Blown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location). Push the bulbs and turn them counterclockwise to remove from the socket.
Where is the brake light switch on my car?
Fuse Box and Light Switch. You have to find the fuse box or the power distribution center (PDC). You will get the fuse panel under the dashboard and the PDC under the hood. The brake light switch is also to be found under the dashboard and check if its plunger touches the brake pedal arm.
Can a old brake light switch be replaced?
Tip: With an older style switch, you may have to adjust the position of the sensor for the lights to work properly. With a little time and patience, you should have your new switch installed and your brake lights should be working.