Are there any DTCs associated with p0342?
DTC P0342 or P0347 may be accompanied by other DTCs, such as P0300 Random Misfire, P0725 Engine Speed Sensor Circuit, or P0335 Crankshaft Position Sensor Circuit Malfunction. None found. Ask a question about P0342 .
Why is my camshaft position sensor not working?
Any unintentional connection to ground could distort or weaken the signal. Other Problems – In case no problems can be found in the CMP sensor or its wiring, it may be that P0342 or P0347 are simply auxiliary fault codes. A jumped timing belt, faulty crankshaft position sensor signal or circuit, or engine misfire, may be the primary problem.
How does the camshaft position sensor work on a VVT engine?
If there are two banks on a VVT-equipped engine, then there will be two camshaft position sensors. The camshaft position sensor reacts to a toothed wheel on the camshaft, which gives the ECU constant information on its speed and position.
What causes a p0342 DTC on a Mustang GT?
Ford Trucks / Mustang GT – An alternator phase problem, such as a blown diode or open coil, may cause so much electrical interference that the CMP signal gets distorted, causing a P0342 / P0347 DTC to set, among others, in spite of there being no actual problem with the CMP sensor or wiring.
What does p0342 mean on a bank 1 sensor?
In this instance, code P0342 infers the sensor’s signal is to low, or not strong enough. The signal is low enough to be vague and difficult to interpret. P0342 refers to the Bank 1 “A” sensor. Bank 1 is the side of the engine that contains cylinder #1. It’s important in today’s vehicles to understand what these sensors are and how they interact.
DTC P0342 or P0347 may be accompanied by other DTCs, such as P0300 Random Misfire, P0725 Engine Speed Sensor Circuit, or P0335 Crankshaft Position Sensor Circuit Malfunction. None found. Ask a question about P0342 .
What is the trouble code for the camshaft position sensor?
The automotive trouble code P0342 is one of several generic malfunction codes relating to the camshaft position sensor (CPS). Trouble codes P0335 through P0349 are all generic codes related to the CPS inferring different reasons for the failure.
Can a low battery cause a camshaft sensor to set?
TSBs are a list of complaints and failures dealt with at the dealer level and the manufacturers recommended correction. Check the condition of the battery. A low battery can cause the code to be set. Check all wiring to the starter. Look for corrosion, loose connections or frayed insulation. Check connector on camshaft sensor.