Why is there oil coming out of my propeller?
The oil that this boater was seeing is probably partially burned 50:1 oil from the engine powerhead. This mixture of oil and carbon builds up in the exhaust chamber of the engine, and eventually will wash off and drain out. The result is a very black oily sludge coming from the propeller.
How do you get a seal out of an axle?
To get the inner axle seals out I use a piece of pipe or a broom stick with a flat end. Slide it into the tube and then angle it into the axle seal where it meets the axle tube. Once you have it in the ‘spot’ give it a whack with a hammer and the seal should start to pop out. You can see the pipe angled into the edge of the axle seal.
Where is the output shaft seal on a rear wheel drive car?
On vehicles that have a rear-wheel drive bias layout, the output shaft seal is at the rear of the transmission extension housing. The seal prevents fluid from leaking out between the transmission and the driveshaft. Vehicles with a front-wheel drive bias layout usually have two output shaft seals (also known as axle seals).
Where is the leak in the transmission shaft?
That gasket can eventually wear out, resulting in a fluid leak. Output shaft seal leaks are a common problem. On vehicles that have a rear-wheel drive bias layout, the output shaft seal is at the rear of the transmission extension housing. The seal prevents fluid from leaking out between the transmission and the driveshaft.
Where is the seal on a transmission pump?
The seal, which is usually located in the transmission pump, fits over the snout of the torque converter. Although not as common as some other issues, it’s possible for a fluid leak to develop from a cracked or porous transmission housing. When the housing is damaged, the fix is usually to replace (rather than rebuild) the transmission.
How to replace a front axle shaft seal?
If you have ever owned a GM four wheel drive vehicle then there is a good chance you have had a front axle shaft seal leak. We replaced the RH output shaft seal on a Tahoe but it is the same for Silverado, Sierra,Suburban and Yukon. Part one shows details on the tear down and part two with guide you through the reassembly. Loading…
How much does it cost to replace a cv shaft seal?
Seal replacement is highly recommended. A lot of seal replacement jobs could have been avoided if the installer of the new axle bothered to replace the oil seal with a new one. The part is around $10 and only adds a few minutes to the job. Either a small pry bar or seal removal tool will work.
How to replace an oil seal on a Chevy truck?
Please try again later. DIY: Here we show how to replace an oil seal or output shaft seal on a rear wheel drive, automatic transmission Chevy truck. Should be the similar for most RWD AT vehicles. The seal in the link is specifically for an ’89 Chevrolet C1500 w/ a 5.7L engine. Make sure the one you buy/order fits your car. Loading…
How do you replace a transmission differential seal?
Use a large socket (around 34 mm) to press the new seal in place (or use a bearing press tool like this one ). Apply gentle taps on the socket to press the seal and observe the progress. The seal should be flush with the transmission differential housing. Do not allow the seal to recess beyond the housing. If it does, pry it out with your fingers.