Why is my throttlestop not working on my laptop?
I restarted my system (no windows updates installed during restart) and have been unable to get Throttlestop to apply the undervolting settings since. When TS Benching I’m again seeing temps back where they originally were, and as high as 94.
Is there a problem with the electronic throttle body?
Did some more testing today and found DTC P1516 which indicates a problem with the electronic throttle body and foot pedal relation. Anyways, the percentage relation between the FPS and the TPS is somewhat out of wack (see attachment). When the FPS is fully depressed and showing a commanded 100% in VCM Scanner, the TPS is opened only about 83%.
What happens when you shut off the throttle?
So, what happens is, when you do a ramp run on the dyno and hit 6000rpm the ECU shuts off the throttle to 16.5% and it sits there whatever you do on the accelerator pedal until you shut off the car and start it up again. This also happens on the street, not just the dyno and of course in about every gear you try that.
What do I need to know about throttlestop guide?
Outside of Undervolting, done in the “FIVR” snap-in, this section is where you will find most of the settings you will likely use to determine the behavior of your CPU. Clock Modulation/Chipset Clock Modulation – These settings were designed to counter an older method of throttling which told the CPU or chipset to run at a percentage capacity.
Can a bad throttle position sensor cause idle surging?
Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges. 3) Check Engine Light
Why is my RTX 2080ti so loud?
As a result the GPU never makes the noises again unless the MSI afterburner setting reset in which case you just need to set it back to 72. Exactly the same problem here, but with RTX 2080ti windforce.
Why does my car stall at low rpm?
The will likely force your computer to stall the engine and only allow it to run at low RPMs, which means the car will only move at slow speeds. This is a safety feature enforced by the computer so that your engine doesn’t get too damaged.
How is the throttle connected to the accelerator?
In the old days, there used to be a cable that was connected from the throttle to the accelerator. But now in the technological age, the car’s computer controls when the throttle opens and closes by the feedback it gets about the acceleration of the vehicle.