Why is my Pi-Star Radio not working properly?
There are several possible causes, including: Using a blocked frequency in the satellite range. Take a look at the frequency selected on the Configuration page. If it is highlighted red, it is in the satellite frequency range and you’ll need to select a different frequency. For more info, see Change frequency below.
What’s the best way to troubleshoot a radio?
Troubleshooting takes time and may really test a person’s patience, but I also find that persistence usually pays off: it feels great to finally figure things out, and I almost always learn some things along the way. Also, make use of the Pi-Star User Forum.
Why is the firmware on my Radio out of date?
Firmware is corrupted or out of date, or the incorrect firmware was flashed for the radio/modem board. You may need to re-flash the firmware. Make sure the firmware you’re flashing matches the board. For more info, see Update or re-flash firmware below.
Why does my son’s 08 G6 not start?
My son’s 08 G6 will not start or even try to turn over. It shows error on odometer after all needles have swung on the cluster.I searched the forum for solutions and tried some to no avail.
Why does my Pontiac G6 say lost communication?
Borrowed a diagnostic tool from a friend and it showed the following… lost communication with engine control module/powertrain control module “A”. Also want to add that battery shows only 9 volts at terminals + neg. cable is a bit loose connecting to battery. Will a low battery cause this lost communication thing?
What causes no start on Pontiac G6 CYL?
A condition has been identified that could cause a NO crank/No communication on the LE5-4 cyl engine. This condition has been identified as a loose ground G105 behind the A/C compressor. Remove the bolt from G105 and clean the engine block surface. You should also make sure the terminal is tight after the bolt is tightened up.