Why is my Hyundai rattling?

Why is my Hyundai rattling?

What are common reasons my Hyundai Sonata engine rattles? While there are a variety of reasons your Hyundai Sonata is rattling, the most common 3 are the ball joints, struts or strut mount, or a problem with the sway bar links.

How do I stop my dashboard from vibrating?

3 Ways to Fix the Rattle

  1. Tighten the Fasteners. You can attempt to tighten any fasteners that hold the plastic part in place.
  2. Tighten the Fasteners With Tape. If you feel that tightening the fasteners isn’t enough, you can remove the part.
  3. Use All-Fit Gap Trim. Install All-Fit gap trim in all the gaps in the dash.

Why is my Hyundai Sonata knocking?

A rod knock is a very serious problem. If your Hyundai Sonata has a knocking rod, it’s almost always going to be caused by a failure of the rod bearing or the rod caps (leading to a spun bearing) or lack of oil.

Where does the vibration come from at 1500 rpm?

As I drive and reach 1500rpm, regardless of speed, I can hear a vibration/rattle noise coming from the front right but because it only happens while it’s in gear and moving, it’s very difficult to find.

What to do about vibration in gear with no throttle?

I’ve seen that this is a common issue with them on many brands. You may be able to have the dealer bump the idle up a bit using Yamaha software and a computer to reset it. A prop change does help sometimes, as it changes the RPM’s just enough at idle to reduce the vibration..

Why does my car have vibration at higher RPMs?

The vibration will still be there if the rpms are tripled, quadrupled, etc. but you likely won’t notice it because at each higher rpm setting, the engine’s firing impulses are closer together and so become less noticeable. There’s no real fix for this other than redesigning the engine, which makes engines more expensive.

How can I reduce the vibration on my pontoon?

A prop change does help sometimes, as it changes the RPM’s just enough at idle to reduce the vibration.. I scoff at your mere vibration after 2 years of “Ole Shakey”, my 50hp Johnson with missing mid section bushings! I scoff at your mere vibration after 2 years of “Ole Shakey”, my 50hp Johnson with missing mid section bushings! LOL ….)…