Why is my gear selector not working on my Mercedes C-class?

The C-Class W203 and pre-facelift W204 has a common fault with the automatic gear selector module / gear lever. This gear selector will cause problems preventing selection of any forward or reverse gears until the ignition is cycled. The gear selector position will not be recognised on the gear display or will show incorrectly.

Why does my Mercedes C class C230 not start?

My 06 c230 is providing fuel while cranking motor over but not priming under accessories mode. (Right before cranking it over) changed out fuel pump relay and fuel pump fuse just to see if that would work. Poured gas in the intake where maf sensor is still no start.

What to do if Mercedes Benz wont shift past 1st gear?

After replacement, the code/s must be erased from the ECM (code P0715) and then also erased from the ETC Module/Trans. Control Module (codes 011-014) as previously supplied. If there is no fluid then by all means visit the mech. with the M/B scanner to narrow down which code (011-014) it is.

Is the VIN on my Mercedes C230 correct?

The VIN is correct on estimate but they have the year wrong. it is a 2007 not 2001. They are saying also needs rear brakes, manifold tumbler total for all would be over $6000. i am inclined to sell it or trade it. 6 people found this helpful.

Can a Mercedes-Benz transmission not go into gear?

Mercedes will start, but transmission won’t go into gear. Shifter can not be returned to Park (P), and you can’t remove the key from ignition. P,N,R,D gear selection indicator on dashboard not displaying correct gear. Mercedes-Benz cars that are equipped with automatic transmission have a gear selector shifter interlock safety feature.

What does it mean when the shifter is stuck on a Mercedes?

Shifter can not be returned to Park (P), and you can’t remove the key from ignition. P,N,R,D gear selection indicator on dashboard not displaying correct gear. Mercedes-Benz cars that are equipped with automatic transmission have a gear selector shifter interlock safety feature.

What are the most common Mercedes Benz transmission problems?

Top 5 Mercedes-Benz Transmission Problems. Won’t come out of Park gear due to a defective brake light switch. ( DIY How to replace the Brake Light Switch) Continue to read if you would like to learn how to troubleshoot your Mercedes-Benz transmission yourself and where you should start. 1. Check Fluid Level

Are there any problems with the Mercedes c250?

Granted, that was the only case reported of a fire, but given the other engine problems, it makes one a little leery of the 2012 C250. Other problems plaguing the 2012 C250 include peeling paint and rattling noises. Is the Mercedes-Benz C250 actually worth it?

What to do if your Mercedes won’t change gear?

Just took it for a run, changes gear very smoothly…new oil also fitted. Mercedes agreed to pay for all the parts, even though the warranty has just run out, so very pleased. Good luck to the others with similar faults, hope you get it sorted. Thanks Madmoose….

Why does my auto box not change gear?

Undervoltage would also cause your gearbox ecu to throw up faults and even cause the autobox to go into safe mode.. You will probably find that a lot of the listed faults have been caused by ..say a low battery.. and when cancelled will not return..

What to do if your gears are stuck on a Mercedes?

If your Mercedes-Benz automatic transmission gear selector is stuck, you can be able to move the shifter from park (P) to drive (D) manually using the shifter override feature found on almost all Mercedes-Benz models including C-Class, E-Class, CL-Class, ML-Class, SLK-Class and other models.

Why is the gear selector on my Mercedes not working?

P,N,R,D gear selection indicator on dashboard not displaying correct gear. Mercedes-Benz cars that are equipped with automatic transmission have a gear selector shifter interlock safety feature. This safety feature locks the shifter in Park when you turn off the ignition.

What is the fault code for Mercedes C class?

Common fault codes: P1856 – Selector Lever Position Detection Failed; P240C – CAN Signal Selector Lever Position N15/5 Is Not Plausible Affected Vehicles: Mercedes A-Class 2004 – 2012 (W169) Mercedes C-Class 2005 – 2009 (W203 and pre-facelift W204) Mercedes CLK 2005 – 2009 (C209/A209) Mercedes CLS 2005 – 2009 (W219)

Why is my Mercedes-Benz transmission not shifting?

If cracks develop between the two chambers, coolant will mix with transmission oil and it will destroy the transmission. This has been a well-documented issue for Mercedes-Benz cars equipped with the Valeo radiators.

What happens when a Mercedes Benz goes into limp mode?

When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level. The transmission has a dipstick tube but with no dipstick in it.

What happens when the gear selector does not work?

The gear selector position will not be recognised on the gear display or will show incorrectly. If the vehicle is in gear when the gear selector module fails you will find that you are not able to select park (P), again until the ignition is cycled.

Where do I send my Mercedes gear selector?

Package the gear selector lever inside a sturdy box with plenty of packaging material (make sure you include your confirmation email in the box). Send us your package by tracked courier (the shipping instructions are on the confirmation email).

Why is my gear selector not working in my Mercedes?

Mercedes cars run into gear selector issues more often, as they are one of the higher-reported problems by drivers over the years. Since the symptoms of gear selector issues can mimic symptoms of other problems, it is important to perform a differential diagnosis to rule-out other causes of the performance symptoms.

When did Mercedes Benz stop making the CLK?

Mercedes-Benz eventually started galvanizing their cars but it wasn’t until around 2004. The production of the W208 CLK-Class stopped in 2002 for the coupe and 2003 for the convertible. Only its successor, the W209 model, received a galvanized body. This is a non-galvanized Mercedes-Benz W220 in a sorry state.

When did the Mercedes Benz CLK W209 come out?

Another option is to get the next generation CLK – the W209 model, which from mid-2003 had much better corrosion protection. The V6 M112 (CLK 320) and V8 M113 (CLK 430 & CLK 55 AMG) engines – Mercedes-Benz got both of them right.

What are the signs of a gear selector problem?

These are the most common signs of gear selector problems: Grinding noises during gear shifting Clicking noises Rough gear shifting Trouble moving from “drive” into “reverse”

Why is my Mercedes Benz gear shift stuck?

Gear shift stuck is one of the most common problems with Mercedes-Benz cars. Unfortunately, looking to see if the brake lights turns on while you press the brake pad, is not a good test to tell if the brake light switch is working properly.

Why does my Mercedes C180 engine not start?

When the engine wont start or when it just dies with no error codes stored it is a fuel delivery problem. This could be caused by a bad fuel pump or a defective CPS (crank position sensor). The CPS often fails when it gets hot. Pouring cold water on it can make it start working again.

What are the gearsticks on a Mercedes C class?

Mercedes Clk W208 / E W210 / C W203 Beige Leather Avantgarde Auto Gear Knob… MERCEDES C-CLASS. ELEGANCE AUTO GEAR KNOB. BLACK/GREY. LOCK NUT INC.

How to reset transmission adaptive shifting in Mercedes Benz?

If you race your Mercedes-Benz, it will remember that and keep the gearbox in gear longer. If you drive it gently, it will adapt to that as well and change gears earlier. Turn the key to position 2. You should see all the dash lights come on. Do NOT start the car.

What kind of engine does a Mercedes C180 have?

Hi everyone – I am driving a Mercedes C180 2004 model, at first it only occasionally started misfiring when low revs or stopped at a stop street. The idling sounded very erratic as well. It only got worse during the past year. One Mercedes specialist told be that my cars engine is a gonner and the timing chain and gears were also damaged.

What’s the problem with my Mercedes C class?

I am having a problem with my C230, 2006 model it has a v6 engine 272 and manual transmission. Now the car starts and idles but does not rev. On the cluster there are two messages that are popping up. .. 1. It says check coolant level 2. Alternator not charging Now coolant is there and the battery is actually full.

Where is the brake light switch for a Mercedes C240 2003?

Where is the brake light switch for a mercedes c240 2003? Which model Mercedes do you have? This car uses the brake pressure sensor mounted on the master cylinder to determine when you are using the braks Customer: My question is where is the brake light switch located. Nothing else I need this answer now. 2003 c240

What to do when automatic transmission won’t shift into 3rd gear?

Check the Throttle Cables. Changing the fluid solves plenty of transmission issues but if the problem of automatic transmission won’t shift into 3rd gear persists, the parts you should check are the throttle cables. A defective cable with excessive slack is likely to create issues with smooth shifting of the gears.

What happens when you reset the transmission shift points?

It is not going to make your shifting abnormal. If your gear shifts are abnormal you have something else going on. Resetting the transmission shift points makes the transmission the same as when the car is out of the factory. Within 30 driving cycles, the ECU will monitor your driving habits and adapt the shifting points to your driving style.

Navigation