Why is my abs light not working on my Chevy?
The fault is usually due to broken solder joints on the circuit board. At this time I did not need to pull the EBCM and repair the solder. Loading…
Why is my brake light not working on my Chevy?
You may have code C0265 “Electronic Brake Control Module Motor Relay Circuit.”. The fault is usually due to broken solder joints on the circuit board. At this time I did not need to pull the EBCM and repair the solder.
Where are the brake lights on my GMC Jimmy?
I have a 1997 GMC Jimmy and the brake lights dont come on when the brake pedal is applied.The emergency flashers work and the fuse is good.All other (int. and ex.) lights work??????? Any members out there have any ideas? Check the brake switch, under the dash, on the brake pedal.
What should you do if your abs light is on?
Just because your ABS light is on, that doesn’t mean you can’t drive your vehicle. In fact, you will still be able to step on the brake pedal and slow the vehicle down. However, you cannot perform any kind of emergency stop by slamming the brake pedal quickly.
What causes an ABS light to come on on a Chevy?
The most common problems that trigger the ABS light on a Chevy vehicle are: 1 Bad ABS wheel speed sensor, 2 Defective steering angle sensor, 3 Damaged wire harness 4 Faulty brake light switch 5 Defective ABS module or pump 6 Poor ground connection 7 Low brake fluid level
Why does my speedometer not work on my GMC Sierra 1500?
– CarGurus Speedometer doesn’t work and transmission doesn’t shift gears. The speedometer stays at 0 all the time. When the transmission is in drive it won’t come out of 1st gear. Reverse works fine, and if I manually put the transmission in 1st or 2nd it works fine.
What does the ABS light on the dashboard mean?
ABS Light is illuminated on the dashboard Since the wheel speed sensor also monitors the anti-lock braking system on your car, it’s common for the ABS Light to illuminate when the sensor is worn out, disconnected, or has been struck by debris, which means you’ll have to replace the wheel speed sensor.
What’s the code for ABS and brake light?
This is how to fix intermittent ABS and Brake dash lights on all Chevrolet vehicles with the Kelsey-Hayes 325 EBCM module. You may have code C0265 “Electronic Brake Control Module Motor Relay Circuit.”