Why has my car window stopped working?
Follow these steps to repair an electrical issue with your car’s windows: Locate and check the fuse for the problematic window motor. If it’s blown, replace the fuse. If you are getting power in both directions of the switch, then the electrical wiring to the motor is good, and the motor should be replaced.
Why are my electric windows on my Saab not working?
Electric windows can be extremely convenient, but when they don’t work, it can become a very frustrating and expensive problem. If your driver window (it also applies to all other windows) decided to go back down to about 2/3, guess it’s the Pinch protection feature .
Where are the switches located on a Saab power window?
No, this is not possible. The 2002 9-3 and 9-5 were fitted with a switch pack assembly housed in the center console which was a single unit. From 2004 onward the switch setup was totally changed with the DDM (Driver Door Module) type switches. These consist of both a microprocessor and switch which is located in the driver’s door.
Can you reset the drivers window on a Saab?
Yes just the drivers window, it will not reset the pinch system. It’s auto one touch goes down but will not auto one touch up. I have spent hours researching this and tried all sorts and it still won’t calibrate.
What to do if your Saab convertible wont close?
(Saab Convertible: Close the door and soft top.) 2. Open the fuse box. To open the case, it must be pushed a bit in direction to the front wheels and than opened as the white part of the picture in shows. Reset the pinch protection by removing and fitting fuse F5 from the instrument panel electrical centre (IPEC).
How to fix the Saab 93 drivers window problem?
Click to expand… If I press automatic down and then pull the switch up to stop the window descending before it is fully open, the window stops ok, but if I then pull the switch up again to raise the window, it continues to lower until it is fully open at which point I can auto raise the window with no further problems.
No, this is not possible. The 2002 9-3 and 9-5 were fitted with a switch pack assembly housed in the center console which was a single unit. From 2004 onward the switch setup was totally changed with the DDM (Driver Door Module) type switches. These consist of both a microprocessor and switch which is located in the driver’s door.
What are the non essentials in a Saab power window?
Non-essentials include power windows, heated seats, wipers and turn signals. However, there could be a problem with the ignition relay or ignition switch. Most often when electrical features begin to behave erratically it is a red flag for a failing ignition switch.
(Saab Convertible: Close the door and soft top.) 2. Open the fuse box. To open the case, it must be pushed a bit in direction to the front wheels and than opened as the white part of the picture in shows. Reset the pinch protection by removing and fitting fuse F5 from the instrument panel electrical centre (IPEC).