Why does the fuse keep blowing on my motorcycle?
I purchased both, installed the items and tried to start up my bike, it turns over than goes dead just a click. So I searched the bike over, and discovered in the fuse box the number 10 fuse blew it says fuel I think. So I put a new fuse in.. same thing happens, turns over than blows the fuse.
Do you need a multimeter if your fuse keeps blowing?
It may be a silly thing to do but sometimes it’s easy to do these things without thinking. If you’re positive the right fuse is installed and the wires aren’t crossed, then you’re going to have to chase the circuit. You’re going to need a multimeter to do so.
What should my Fuse reading be on my motorcycle?
Really all you are checking is that the wire connecting the battery and light bulb is in good condition. Your meter should be set to read ohms. Touch the test leads together as a reference- on most meters this will register around 0.9 ohms.
Why does my fuel pump fuse keep blowing?
If you’re positive you have the right amperage fuse in it [check your owners manual] then it has to be a faulty circuit. When you installed the new fuel pump, is it possible you switched around the wires, so perhaps the ground is receiving power and the power is grounded?
I purchased both, installed the items and tried to start up my bike, it turns over than goes dead just a click. So I searched the bike over, and discovered in the fuse box the number 10 fuse blew it says fuel I think. So I put a new fuse in.. same thing happens, turns over than blows the fuse.
It may be a silly thing to do but sometimes it’s easy to do these things without thinking. If you’re positive the right fuse is installed and the wires aren’t crossed, then you’re going to have to chase the circuit. You’re going to need a multimeter to do so.
Really all you are checking is that the wire connecting the battery and light bulb is in good condition. Your meter should be set to read ohms. Touch the test leads together as a reference- on most meters this will register around 0.9 ohms.
Why does the fuse keep blowing on my Tractor?
When I plugged the double lined plugs together, the two black wires coming from the stator into the two yellow wire of the voltage regulator and turned the key switch. The fuse blew.
How often do you get a blown fuse?
Most people probably have experienced a blown fuse at one time or another. Someone always knows what to do when this happens. If you’re a homeowner, that person probably is you. Blown fuses are a common occurrence.
Can a blown fuse be switched back on?
The breakers reset and can be “switched back on”–so there is no need to replace anything. Much of the time, it’s technically inaccurate to refer to a “blown fuse,” so in this article, we’ll offer you some new concepts and vocabulary to describe your various electrical concerns.
What should I do if my motorcycle fuse keeps blowing?
Fuse keeps blowing help!! Hello, my motorcycle keeps blowing a fuse. I purchased the bike and took it to the shop and had the mechanics look at it, they tested it and told me the bike needs a fuel pump and a new battery and it would work fine.
Most people probably have experienced a blown fuse at one time or another. Someone always knows what to do when this happens. If you’re a homeowner, that person probably is you. Blown fuses are a common occurrence.
The breakers reset and can be “switched back on”–so there is no need to replace anything. Much of the time, it’s technically inaccurate to refer to a “blown fuse,” so in this article, we’ll offer you some new concepts and vocabulary to describe your various electrical concerns.
What causes a circuit breaker to blow a fuse?
Any faulty wiring or connected parts risk a power fault (surge), which trips a circuit (or blows a fuse). So, again, the problem is not that the circuit breaker (or fuse) didn’t do its job but rather that there was faulty equipment.
Where to find a blown fuse or reset a circuit breaker?
2 Locate and open your electrical panel. It’s usually found in the basement or in a utility room. For more information about your electrical panel, read: Get to Know Your Electrical Panel. 3 Always use caution.
Where are the fuses on a Harley Davidson?
Hi Kelly, Under your left side cover, you will find a fuse block containing headlamp, ignition, lighting, instruments, brakes, cruise, radio memory, radio power, accessory, etc fuses. You will need to remove the fuse block cover to access these fuses. It is a black, plastic cover.
Where is the fuse panel on 1989flhtcu?
Found them they were covered in dust after removing the dust from the top I could see the map to the fuses. It’s not on the left side unless you have to take apart one of the 2 boxes located on the left side. Where is the fuse panel on 1989FLHTCU ?
What’s the amp rating on a motorcycle fuse?
Fuses have preset amperage ratings that are written on the fuse. The most common sizes on motorcycles are 5, 10, 15, 20, and 30 amp. Somewhere on the fuse it will have the amp rating printed, like 5A or 20A. The amp rating means how much current that system can take before the fuse blows in order to protect it. You should not mix and match fuses.
Where is the fuse box on a motorcycle?
On older motorcycles, the fuse box is usually found underneath the handlebar cover (the little plastic cover that goes over the middle of the handlebars). On newer motorcycles, the fuse box is either located under the seat or near the battery.
If you’re positive you have the right amperage fuse in it [check your owners manual] then it has to be a faulty circuit. When you installed the new fuel pump, is it possible you switched around the wires, so perhaps the ground is receiving power and the power is grounded?
Why does my electric bike shut off after 3 months?
If you haven’t left it three months without charging, it could be a controller cutout operating due to a bad connection from battery to bike also causing inadequate current supply and low voltage, so try cleaning the connections on battery and bike.
How do you replace a fuse on a Rad Power bike?
Use needle nose pliers to grip the fuse housing and pull the fuse directly outwards. If the fuse is difficult to pull, use the awl to pry each side of the fuse to rock it out the housing. Recycle the fuse according to local rules. Continue to the next section to install the new fuse. Install the replacement fuse.
What should I do if I Blew my Fuse?
The Fix: Make sure the faulty device is unplugged and there is no damage to the outlet. First, test the circuit. Then check for any damage on or around the electrical panel. If you see any damage, call an electrician before doing anything else with it. If there is none, flip the breaker switch back to its operating position.
What happens if your battery fuse is not installed?
Riding without fuse covers properly installed can lead to battery damage caused by water intrusion, or lead to serious injury or death. Get the bike ready for maintenance. Turn off the bike, remove the battery, and press and hold MODE (or the power button) to discharge remaining power.
How to diagnose a fuse that keeps blowing?
(EASY) DIAGNOSING A FUSE THAT KEEPS BLOWING, ELECTRICAL (SHORT CIRCUIT, NO START) / ARE YOU SAVED? – YouTube (EASY) DIAGNOSING A FUSE THAT KEEPS BLOWING, ELECTRICAL (SHORT CIRCUIT, NO START) / ARE YOU SAVED?
Where is the fuse box on a 1996 Honda Accord?
1996 Honda Accord Fuse layout under hood fuse box and relay box The under hood fuse box is located to the rear of the engine compartment on the passenger side near the firewall. The relay box is located slight forward of the under hood fuse box. Honda Accord under hood fuse layout for 4-cylinder
Where is the fuse box on a Honda Civic?
The under-hood fuse box is located in the engine compartment next to the battery. To open it, push the tab as shown. Cars equipped with ABS have a third fuse box for the ABS. It is in the engine compartment on the passenger’s side.
What’s the ignition fuse on a Honda 10A?
10A is the ignition fuse. Same thing happened to me couple months ago and I have the same model and year. Kept blowing the ignition fuse, no FI light, no fuel pump, etc. Checked all the wiring, good.
Why does the IGN fuse keep blowing out?
Been having some trouble the last few days and yesterday it wouldn’t start and all i could hear was buzzing so tried a boost and it ran fine and a few hrs later tird it again and it wouldn’t go on a boost. Now im seeing that when i turn the key the ign fuse is burnning out?
10A is the ignition fuse. Same thing happened to me couple months ago and I have the same model and year. Kept blowing the ignition fuse, no FI light, no fuel pump, etc. Checked all the wiring, good.
Why does the 10A IGN fuse keep blowing out?
When the PGM-FI unit goes bad it can blow the 10A ign fuse, don’t know why or how cause they’re sealed and for added insurance, recommend replacing the regulator as well, but as shadetree mentions above check for corroded grounds or open wires first, before blowing 200 bucks for new parts. bad CDI?