Why does the brake light not come on on my Volkswagen?
Your Volkswagen may have a small plastic pad at the switch attached to the pedal that connects with the switch. This plastic pad may break or become dislodged, which means the brake may not push the switch. This can cause light problems.
Why are the brake lights not working but the tail lights are?
Blown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location). Push the bulbs and turn them counterclockwise to remove from the socket.
How do you replace a brake light switch?
Jim, check you brake light switch. Check on here for more information. To replace the switch :” On the new brake switches you START with the plunger all the way out. Holding the brake pedal UP install the brake switch and turn until it latches. This will set the Plunger in the correct spot.
Is it dangerous to drive with brake lights not working?
Driving at night with either brake lights or tail lights not working is dangerous for you and other drivers on the road. It takes a long time to notice when the brake lights not working but tail lights are or vice versa. It is so because you won’t know what is happening in the backside while driving until someone points it out.
What happens if you have a bad brake light switch?
The brake light switch on modern vehicles is no longer a simple switch used to turn on the brake lights. A bad brake light switch, for example, can trigger the ABS and traction control lights, but it can also prevent engine start or even transmission shifting. In this article, we go over the symptoms of a bad brake light switch and test them.
Where is the brake light switch on a car?
When the brake pedal is pressed, it closes the switch, and the current flows through the wiring to the brake lights. This turns on the rear brake lights. The brake light switch can also be located on the master cylinder. Hydraulic pressure from the master cylinder brake light switch system can close the switch to turn on the brake lights.