Why does my Jeep Wrangler shudder when I put it in gear?
I have a 2012 Jeep Wrangler Unlimited auto trans, around 80,000 miles. This started a few months ago. When I start it cold, like after sitting overnight, it starts fine, sounds fine. But when I put it in gear (D or R), it either shudders and RPM’s drop and feels like it’s going to stall, or it actually stalls.
Why does my Jeep Cherokee stall while driving?
A significant number of drivers have reported that not only did their Jeep Cherokees lose engine power while driving, but in nearly all cases, stalling occurred without any warning and with no indicator lights on the instrument panel.
Can a car stall when put in gear?
For the car, stalling is exactly the dead engine. No one wants to experience this frustrating feel. Basically, you can catch a car to stall when put in gear. Don’t worry if you have to face this issue because we have prepared the bottom information if your car engine gets stalled.
Can a Jeep Wrangler go into R or D?
Yes Bevan go to the link below To page 21-528 about half way down the page it shows Engine stalls when shifting into r or d It will show no codes the techs need to read the manual not there tester as usual Highly active question. Earn 10 reputation in order to answer this question.
Can a Jeep Cherokee stall at high speeds?
There are countless instances of Jeep Cherokees stalling while traveling at low speeds or high speeds, driving straight or losing power in the midst of a turn. While certainly frustrating, these stalls can also have serious consequences.
I have a 2012 Jeep Wrangler Unlimited auto trans, around 80,000 miles. This started a few months ago. When I start it cold, like after sitting overnight, it starts fine, sounds fine. But when I put it in gear (D or R), it either shudders and RPM’s drop and feels like it’s going to stall, or it actually stalls.
What causes a car to stall once it’s put into gear?
This solenoid can stay stuck on and cause the torque converter to stay locked up, this will cause the vehicle to stall whenever it is put into gear. The vehicle will start and run fine in park or neutral but will stall out as soon as it is put into gear.
Why does my Jeep Wrangler stall in reverse?
Chrysler has found the torque converter is a problem going into lock up mode when putting in reverse making it sputter shudder and stall Yes Bevan go to the link below To page 21-528 about half way down the page it shows Engine stalls when shifting into r or d It will show no codes the techs need to read the manual not there tester as usual