Why does my Jeep Liberty turn over but not start?
When attempting to start the engine, it turns over normally but will not start. The engine does not even attempt to start. Found the problem, a mouse had chewed through a wire located near the ECU. The ECU is located on the fender by the right side hood hinge.
What is the condition of my Jeep Liberty?
When the key is turned to the “Start” there is absolutely nothing. No clicking from solenoid or attempt to do anything. 1. Battery has been ruled out. Swapped battery from my car and condition is the same. 2. Cables are good. 3. BCM is good. Lights, Horn, Radio, Key Fob. etc etc working normally. 4.
Are there skim keys on a Jeep Liberty?
One interesting thing is that the Security LED on the dash is lit during all of this. Also, the Jeep doesn’t use the SKIM system for the keys/ignition. Mine are just the normal black (Non SKIM) keys, One interesting thing is that the Security LED on the dash is lit during all of this.
What to do if your Jeep won’t start?
Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!
What does it mean when your Jeep Liberty won’t start?
The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Liberty won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.
When was the last time a Jeep Liberty had a crank condition?
This topic contains 27 replies, has 8 voices, and was last updated by dreamer2355 9 years, 1 month ago. Hi everyone, Newb here with his 1st post.
One interesting thing is that the Security LED on the dash is lit during all of this. Also, the Jeep doesn’t use the SKIM system for the keys/ignition. Mine are just the normal black (Non SKIM) keys, One interesting thing is that the Security LED on the dash is lit during all of this.
What happens when a Liberty starter goes bad?
When a starter goes bad, they will usually not give you much warning first. Also, if you are stuck somewhere and are trying to start your Liberty, the old beat the starter with a hammer trick is not a wives tale. It really can get that one last start out of it. There are a lot of issues that can cause your Liberty to crank, but not start.
What causes a Jeep Liberty engine to overheat?
If your Liberty’s engine gets hot enough, the coolant will begin to boil over and manifest itself as steam coming up from under the hood. It does this to relieve the pressure on the cooling system before lasting damage can be done to it. 3. Blown Head Gasket
How does the cooling system on a Jeep Liberty work?
Your Liberty’s cooling system works by cycling the engine coolant from the engine through the radiator. The water pump pushes the water through the entire system. The thermostat opens up once the engine reaches operating temperature and allows coolant in.
What is temperature gauge on Jeep Liberty 3.7L?
I have a 2006 Jeep Liberty 3.7L that has a temperature gauge on the dash that reads an overheat when driving. The oil looks normal, there is no white smoke, no bubbling from reservoir. I have replaced the following:
What are the symptoms of a Jeep Liberty overheating?
Common symptoms of overheating include smoke coming from under the hood, a pegged temperature gauge, and a blown head gasket. Overheating can cause a lot of expensive damage to the engine. A blow head gasket or a cracked head/block are much more expensive to repair than a thermostat or water pump. How Your Liberty’s Cooling System Works
When attempting to start the engine, it turns over normally but will not start. The engine does not even attempt to start. Found the problem, a mouse had chewed through a wire located near the ECU. The ECU is located on the fender by the right side hood hinge.
I have a 2006 Jeep Liberty 3.7L that has a temperature gauge on the dash that reads an overheat when driving. The oil looks normal, there is no white smoke, no bubbling from reservoir. I have replaced the following:
Your Liberty’s cooling system works by cycling the engine coolant from the engine through the radiator. The water pump pushes the water through the entire system. The thermostat opens up once the engine reaches operating temperature and allows coolant in.
Are there any problems with the Jeep Liberty?
The Liberty was fairly popular in its day, but it was not without its problems as well. If you’re interested in picking up a used Liberty for yourself, it’s good to be familiar with the problems that the various model years were faced with.
Why does my Jeep Wrangler shut down while driving?
If your Jeep Wrangler is shutting down while driving, it’s a real safety hazard. Vehicles are a lot harder to control without power brakes or steering. Directly below is a list of the most common reasons why your Wrangler would randomly die while driving. It may help you in your diagnosis.
When did the Jeep Liberty go out of production?
July 16, 2020 by Tom Harbid Jeep produced the Liberty as a compact SUV that would sit in their lineup between the Wrangler and the Grand Cherokee. It was in production for 10 years from the year 2002 until the year 2012. When it was replaced in 2012, the Jeep Cherokee took over.
Is there a problem with the Jeep Liberty Diesel?
This problem pertains to the 2006 Jeep Liberty crd 2.8L diesel. Under acceleration from 55 mph to 65 mph, the vehicle stalled and would not go over 3,000 RPM. When the vehicle slowed to 45 mph, it would not increase speed, effectively in a “limp-in mode”. after the vehicle stopped, the engine was shut off for about 2 minutes then restarted.
How can I get more fuel out of my Jeep Liberty?
Bled the air out by opening th the little nipple on the side of the fuel filter with the 11mm wrench but close it before the air stops coming out. Repeat the pump till it gets hard and letting the air out till bubble free fuel comes out.
What was the problem with my 06 Liberty?
My 06 liberty was running fine it seemed ! It been running 30 minutes with no problem.it sat idling while i put the fam in the car,and we started driving.about a half mile away i came to a stop sign,when i went to take off,it choked bad but then it caugh n was still running and i went ! 2 blocks later ? It stalled !
Why did my Jeep Liberty Diesel engine die?
2006 Jeep Liberty diesel with 14,500 miles. Engine dies 10-15 seconds after start. Fuel system must be primed with pump on fuel filter head in order to restart engine. Fuel is seeping from the fuel heater electrical connector located on the filter assembly. Dealer replaced fuel filter assembly as a warranty repair.
What was the problem with the 2006 Jeep Liberty?
2006 Jeep Liberty crd fuel filter separator heater element evidence of pending failure and leak and fire hazard; browning of plug contact and air in system due to some sort of slow leak.
What kind of fuel system does Jeep Liberty have?
Several things 2 list: Vehicle = 2.8L diesel Jeep Liberty, 2006. The codes are P0093 & U0121. 1st) it says a large leak in the fuel system. Something in the emission system. Has happened several X’s.
Where is the ECU on a Jeep Liberty?
The ECU is located on the fender by the right side hood hinge. Spliced the wire and wallah it starts and runs normally!!!! Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!
With the key in the “start” position, if the starter motor is getting power but the starter doesn’t work, then the starter is condemned and replaced. Note that starters can and do sometimes develop intermittent faults due to bad spots on the armature.
Why is my key stuck in the ignition?
If the key is stuck in the start position, this is a ignition lock cylinder issue and the reason the starter continues to turn the motor over. If the starter is turning but the motor is not, then the starter is likely the problem.
What to do when your Jeep Liberty won’t start?
When it does not start there is no crank. I have replaced the starter, Ignition switch, Ignition switch actuator pin, battery, battery cable’s, shifter cable was adjusted, small wire that goes to starter replaced that end, had the range sensor checked out! That not bad, checked relays, checked under relay box for corrosion!
The ECU is located on the fender by the right side hood hinge. Spliced the wire and wallah it starts and runs normally!!!! Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!
Why does my Jeep not start when I Turn on the ignition?
If your vehicle does not have a check engine light this may not be a problem. It is possible that this is just the sound that the vehicle makes normally. If you’ve owns the vehicle for quite some time and… Engine heat can degrade components such as ignition coils and the crankshaft position sensor. The components will then fail once they are hot.
When did my 2012 Jeep Liberty not start?
I have a 2012 Jeep Liberty and this started close to 2 years ago now. Randomly would not start every once in a while (it would crank but not start). Went to goodyear, they replaced my throttle body, did a bunch of other work (close to $1,000) and then 6 months later it started again.
My 06 liberty was running fine it seemed ! It been running 30 minutes with no problem.it sat idling while i put the fam in the car,and we started driving.about a half mile away i came to a stop sign,when i went to take off,it choked bad but then it caugh n was still running and i went ! 2 blocks later ? It stalled !
Why are the rear rotors on my liberty making a noise?
The first time they replaced the rear rotors as they had corrosion from sitting on the lot (a fairly common problem according to a friend who is a mechanic). However, the noise returned after a few days. I have been told that the noise is a result of the metal pads and rotors used on the Liberty.
Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!
How much does a Jeep Liberty no start cost?
The average cost for a Jeep Liberty No Start Diagnosis is between $88 -$111. Learn More Every couple of months, with no rhyme or reason, the vehcile will not start even if it was JUST running 2 minutes prior.
I have a 2012 Jeep Liberty and this started close to 2 years ago now. Randomly would not start every once in a while (it would crank but not start). Went to goodyear, they replaced my throttle body, did a bunch of other work (close to $1,000) and then 6 months later it started again.
Why does my Jeep not start when it’s warm?
If its a starter issue it WONT crank, when some part of the starter system is failing or failed it wont turn over. Very different from cranking and not starting. If your getting clicking, you may have a weak battery, poor connection or dying starter (likely one of the prior).