Why does my Chainsaw stall when I press the throttle?
If your chainsaw stalls instead of producing the reassuringly high-pitched sound of a healthy engine when you press the throttle trigger, something is interfering with efficient fuel combustion.
Why is my car stalling at high speeds?
You take your foot off the gas pedal to apply the brake, but your engine begins to idle very roughly, and then it stalls. Yet, when you restart the engine and run the car at higher speeds, it seems to run fine, or at least more smoothly. Here’s what could be wrong: If you have a carburetor, you may have a bad accelerator pump or power circuit.
Can a car stall with a bad throttle position sensor?
The engine can stall for no reason and without any warning. This happens when the TPS gives incorrect information to the ECM. The engine can stall at high speed, at low speed, or even at idle. A faulty throttle position sensor will not let your car accelerate normally. Though this doesn’t happen all the time.
When does a car cut out when you give it throttle?
It will cut out when you give it throttle, it always is preceded with one hesitation. When acceleration is applied it staggers and farts, until you let off the throttle, then it will run fine at an even RPMs until accelerator is pushed. It will always start right up if it dies and will idle. And run when stopped, in neutral or in gear and rolling.
Why does my hedge trimmer idle but die at full throttle?
Hedge Trimmer: Engine Will Idle But Dies At Full Throttle If your hedge trimmer engine idles, but stops at full throttle, you will need to check the following parts: the fuel lines, gasket, carb kit, carburetor, and spark plug. This is a relatively common symptom and our repair guide can help you fix it. Note: this is a general repair guide.
If your chainsaw stalls instead of producing the reassuringly high-pitched sound of a healthy engine when you press the throttle trigger, something is interfering with efficient fuel combustion.
The engine can stall for no reason and without any warning. This happens when the TPS gives incorrect information to the ECM. The engine can stall at high speed, at low speed, or even at idle. A faulty throttle position sensor will not let your car accelerate normally. Though this doesn’t happen all the time.
What should I do if my trimmer engine stalls?
If your trimmer engine idles, but stalls on throttle, check the following parts: the gasket, primer bulb, fuel filter, air filter, fuel vent, fuel line, and carburetor. The repair and symptom guide will help you better identify the part needed to be replaced and how.
Hedge Trimmer: Engine Will Idle But Dies At Full Throttle If your hedge trimmer engine idles, but stops at full throttle, you will need to check the following parts: the fuel lines, gasket, carb kit, carburetor, and spark plug. This is a relatively common symptom and our repair guide can help you fix it. Note: this is a general repair guide.
Where is the spark arrestor on a chainsaw?
The air filter is under a cover on the engine housing, and the spark arrestor is between the exhaust port and the muffler. Both are easy to remove and service. A dirty fuel filter restricts fuel flow, which also kills the engine. The fuel filter is usually in the gas tank and easily removable and replaceable.
Where is the fuel filter on a chainsaw?
The fuel filter is usually in the gas tank and easily removable and replaceable. If your chainsaw has been in storage, the fuel may need to be replaced. When gasoline is left standing in the fuel lines and carburetor, it partially evaporates, leaving behind a varnish-like substance that clogs the fuel system.
Why does my Chainsaw not run at full throttle?
My chainsaw will start and idle but won’t run or stalls when I go to full throttle. What’s wrong? There are several things you can check. First, make sure that you are using fresh fuel mix (never store or use fuel mix older than 60 days in can or fuel tank). Second, clean spark arrester screen in the muffler.
The air filter is under a cover on the engine housing, and the spark arrestor is between the exhaust port and the muffler. Both are easy to remove and service. A dirty fuel filter restricts fuel flow, which also kills the engine. The fuel filter is usually in the gas tank and easily removable and replaceable.
The fuel filter is usually in the gas tank and easily removable and replaceable. If your chainsaw has been in storage, the fuel may need to be replaced. When gasoline is left standing in the fuel lines and carburetor, it partially evaporates, leaving behind a varnish-like substance that clogs the fuel system.