Why does my Bronco only start with spout connector out?
These concerns may be caused by the shielding drain wire (Circuit 48.) cutting through the insulation of, and shorting to, the Profile Ignition Pickup (PIP) wire (Circuit 395) or the spark output (SPOUT) wire (Circuit 929) near the Powertrain Control Module (PCM) 60-pin connector.
Why does my truck only start with the spout connector out?
Will only start with Spout Connector out. Hello everyone I have a 88 Bronco with a 5.0. I am trying to trouble shoot why my truck only starts when the spout connector is out. I started haveing this issue a few weeks ago it wouldn’t happen every time just every now and then. Now it happens every time I try to start the truck.
How does plugging in the spout enable the ECM to?
Ford F150 XLT I know how plugging in the SPOUT enables the… You really want to know? 1994 f-150, 4.9 with automatic. It You really want to know? 1994 f-150, 4.9 with automatic. It won’t start with the spout connector installed. Timing is at exactly 10 degrees btdc … read more
Where does the ICM connector start on a Bronco?
Unravel aluminum foil tape and electrical drain wire (Circuit 48.) from main bundle, exposing the junction or “Y” splice between the ICM tapeout and the PCM tapeout. Be careful with the foil wrap because it will be reused. NOTE: THE FOIL WRAP LENGTH WILL BE ABOUT 5″ (127mm) BEYOND THE “Y” BRANCH. THE END WILL BE TOWARD THE ICM CONNECTOR.
These concerns may be caused by the shielding drain wire (Circuit 48.) cutting through the insulation of, and shorting to, the Profile Ignition Pickup (PIP) wire (Circuit 395) or the spark output (SPOUT) wire (Circuit 929) near the Powertrain Control Module (PCM) 60-pin connector.
Will only start with Spout Connector out. Hello everyone I have a 88 Bronco with a 5.0. I am trying to trouble shoot why my truck only starts when the spout connector is out. I started haveing this issue a few weeks ago it wouldn’t happen every time just every now and then. Now it happens every time I try to start the truck.
Ford F150 XLT I know how plugging in the SPOUT enables the… You really want to know? 1994 f-150, 4.9 with automatic. It You really want to know? 1994 f-150, 4.9 with automatic. It won’t start with the spout connector installed. Timing is at exactly 10 degrees btdc … read more
Unravel aluminum foil tape and electrical drain wire (Circuit 48.) from main bundle, exposing the junction or “Y” splice between the ICM tapeout and the PCM tapeout. Be careful with the foil wrap because it will be reused. NOTE: THE FOIL WRAP LENGTH WILL BE ABOUT 5″ (127mm) BEYOND THE “Y” BRANCH. THE END WILL BE TOWARD THE ICM CONNECTOR.