Why does my ASD fuse keep blowing out?
Most blowing ASD fuses revolve around shorted oxygen sensor heaters or the wiring going to the oxygen sensors. Look for a wiring harness that fell down onto hot exhaust parts. If everything looks okay, unplug the O2 sensors, then if the short appears to be gone, reinstall the ASD relay and fuse then try to start the engine.
What to do if your fuse keeps blowing?
Don’t wiggle wiring harnesses around in hopes of getting it to not blow another fuse because then there’s no defect to find. Once it is in the defective state, insert a pair of spade terminals in place of the blown fuse, then use a pair of jumper wires to connect them to a 12 volt light bulb.
Why does my TCM fuse blow when I start the engine?
Unplug those sensors. The ignition coil and injectors are in this circuit. They are turned off by the Engine Computer removing their ground circuits, so even if one of those parts were shorted, the fuse wouldn’t blow until you started cranking the engine. That eliminates the coil and injectors as suspects, but not the wires going to them.
Why does fuse keep blowing on Sebring fuel pump?
I just got a 2002 sebring convertable ( limited version ) after 3 days of use the 20 amp fuse for the starter/fuel pump blew. replaced it and it started fine.
Most blowing ASD fuses revolve around shorted oxygen sensor heaters or the wiring going to the oxygen sensors. Look for a wiring harness that fell down onto hot exhaust parts. If everything looks okay, unplug the O2 sensors, then if the short appears to be gone, reinstall the ASD relay and fuse then try to start the engine.
Unplug those sensors. The ignition coil and injectors are in this circuit. They are turned off by the Engine Computer removing their ground circuits, so even if one of those parts were shorted, the fuse wouldn’t blow until you started cranking the engine. That eliminates the coil and injectors as suspects, but not the wires going to them.
What to do if your fuse blows on your car?
Look for a wiring harness that fell down onto hot exhaust parts. If everything looks okay, unplug the O2 sensors, then if the short appears to be gone, reinstall the ASD relay and fuse then try to start the engine.
Where is the underhood fuse located on a Honda Accord?
The center instrument panel utility block is located underneath the instrument panel, to the left of the steering column. The underhood fuse block in the engine compartment on the driver’s side of the vehicle near the battery.
How can you tell when a fuse has been blown?
You might be wondering, then, how to tell if a fuse is blown–an actual fuse, that is. You will see that the fuse has melted, and there might be charring on the panel. A true fuse typically consists of a piece of metal, most commonly an encased wire, that actually melts when overheated. This is what stops the fault (aka “short” or “power surge” ).