Why did my Mazda 6 diesel break down?

Why did my Mazda 6 diesel break down?

Oil level rises between services. Some is expected because of the DPF. – 32 000km car breaks down – oil warning light. Issue is very likely related to rising oil level. Car is towed to Mazda with no fault found – Oil level continues to rise so I do my own oil change at 37 000.

What happens if you have low oil pressure on a Mazda 6?

One of the most serious issues that can happen to your Mazda 6 ‘s engine is if ends up with low oil pressure. Low oil pressure will cause the engine to seize up. When the oil pressure light on, it should be assumed that the engine locking up is imminent. We advise not running the engine until the issue can be properly diagnosed.

How long have I owned a Mazda 6 diesel?

I owned a 2010 Mazda6 diesel for 6 six years. I sold the car with 160000km. About 85% of these kilometers were open road. In that time the oil level never increased between changes. And as far as I know it never went through an active DPF regeneration. Fuel consumption was always a constant 6.0L/100km. I currently own a 2016 Mondeo diesel.

How much fuel does a Mazda 6 burn?

It has endless torque and is a little pocket rocket. It does though do its DPF burns evidenced by increased idle speed, very hot exhaust and hugely increased fuel consumption – eg at 60km/h it goes from 3.6 to 7.6 during the burn. It’s a bit self defeating, using up the very commodity you are trying to save with fuel efficiency.

Is there a recall on the Mazda 6?

The affected Mazda 6s were built from May 20, 2013 through December 4, 2013. Mazda dealers will reprogram the Power Control module with updated software to correct the problem. The recall is expected to begin in late April. Owners can contact Mazda at 1-800-222-5500. Edmunds says: This recall will begin shortly.

Is there a recall on 2014 Mazda 3?

The recall is expected to begin in late April. WASHINGTON — Mazda is recalling approximately 5,700 2014 Mazda 3 and 2014-’15 Mazda 6 cars because charging system shutdown may cause engine stall, according to the National Highway Traffic Safety Administration.

What causes the Check Engine light to turn off at idle?

At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges. The check engine light will randomly turn on and off even if the car is running smoothly without any jerks and stalling.

What causes idle surges on a car ECM?

Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges.

How often do I have to change the oil on my Mazda 6?

– 50 000 oil is dangerously high again, Mazda won’t agree to pay for the oil change. So as it stands I’m getting 4000km before the oil is at the X mark on the dipstick. This is nothing like the 10 000km interval. My driving is 40km commute twice daily on the freeway with flowing traffic.

Is the Mazda 6 still under manufacturer warranty?

– Car still under manufacturer’s warranty, 2013 Atenza 6 @ 50 000km. All services done on time by Mazda. – Bought at 13 000km. Oil level rises between services. Some is expected because of the DPF. – 32 000km car breaks down – oil warning light. Issue is very likely related to rising oil level. Car is towed to Mazda with no fault found

What should I do for my Mazda 6?

*3: If the vehicle is operated in very dusty or sandy areas, inspect and if necessary, clean or replace the air cleaner element more often than the recommended intervals. *4: This is a full function check of electrical systems such as lights, wiper and washer systems (including wiper blades), and power windows.

When to replace air cleaner in Mazda 6?

Extended periods of idling or low speed operation. c. Driving for long period in cold temperatures or driving regularly at short distance only. *3: If the vehicle is operated in very dusty or sandy areas, clean and if necessary, replace the air cleaner element more often than the recommended intervals.

How often do you change the oil in a Mazda 6?

*2: If the vehicle is operated under any of the following conditions, change the engine oil and oil filter every 10,000 km (6,000 miles) or shorter. a. Driving in dusty conditions. b. Extended periods of idling or low speed operation. c. Driving for long period in cold temperatures or driving regularly at short distance only.

How can I tell if my Mazda 6 fuel pump is bad?

Testing your 6’s fuel pressure on each side of the pump would be the best way to diagnose this problem. A priming fuel pump sounds like a high-pitched whine for a few seconds and can be heard with a sharp engine right after the ignition key is turned, but before the starter is engaged.

Is it safe to buy a Mazda 6 diesel?

Question being about the advisability of buying a new diesel. Apparently it conforms to Euro 6 emissions, whatever the Hell that is, and he doesn’t give a flying flea about the current downer that the car buying public seem to have on diesels.

Why does Mazda 5 and 6 diesel oil sump level rise?

Why does the Mazda 5 & 6 diesel oil sump level rise? Sump oil level rising on the Mazda 5 and 6 diesel engine is a very common issue, and can be a good indication of the condition of your DPF (Diesel Particulate Filter). But first lets explain what a DPF is and how it can affect your oil level.

Can a bad fuel filter cause a Mazda 6 to stall?

One of the worst problems that can happen to your Mazda 6 is a bad fuel filter. When the filter goes bad, it can limit the amount of fuel that enters the engine. Without fuel, the vehicle will not run at all. With that in mind, most of the symptoms of a bad fuel filter revolve around the vehicle stalling out.

Testing your 6’s fuel pressure on each side of the pump would be the best way to diagnose this problem. A priming fuel pump sounds like a high-pitched whine for a few seconds and can be heard with a sharp engine right after the ignition key is turned, but before the starter is engaged.

What are the symptoms of a bad fuel pump?

The symptoms of a bad fuel pump match a lot of other common problems that can occur in the Mazda 6. Testing the filter and pressure on each side of it are going to be the quickest ways to rule it out. If there is anything you would like to add, please leave a comment below.

Where is the fuel filter on a Mazda BT-50?

This meant the fuel filter was no longer left under the hood. It was put in the steel fuel line, between the gas tank and engine bay. These fuel filters were more reliable, but they also were tougher to change. Repairing them means getting under the vehicle and disconnecting steel fittings.

How did Mazda come up with the idea of making cars?

In addition, Mazda engineers received at their disposal the technology of a new partner, which formed the basis for all future models of the Japanese brand.

Oil level rises between services. Some is expected because of the DPF. – 32 000km car breaks down – oil warning light. Issue is very likely related to rising oil level. Car is towed to Mazda with no fault found – Oil level continues to rise so I do my own oil change at 37 000.

How much does a Mazda6 manual transmission cost?

Monthly Estimate based on a 4.4% rate for 60 months, $7,499 vehicle price, $0 down payment, $0 trade-in, $0 sales tax. Car was misrepresented on line. Ad said turbo manual shift….

When do Mazda doors and liftgates lock automatically?

A beep sound is heard when all doors and the liftgate are closed while the advanced key is being carried. All doors and the liftgate are locked automatically after about three seconds when the advanced key is out of the operational range. Also, the hazard warning lights flash once.

How many locks are there on a Mazda transaxle?

There are only a total of six auto lock/unlock settings available for automatic transaxle vehicles, and three for manual transaxle vehicles. Be sure to press the unlock side of the door-lock switch the correct number of times according to the selected function number.