Why did my Jeep Wrangler lose traction control?
The contact owns a 2016 Jeep Wrangler. The contact stated while driving at various speeds, the traction control and abs warning light illuminated. The contact stated that as the warning lights illuminated, the vehicle decelerated and then attempted to regain traction control. The contact stated that the failure was intermittent.
What’s the traction control light on a 2014 Wrangler?
JKU windshield shade Quick release mirror 2014 Wrangler traction control light and check engine light on??? Discussion in ‘ Wrangler JK (2007-2017) ‘ started by Dlparker94, Mar 21, 2019 . hello, i recently purchased a 2014 wrangler and have taken it on a 10 hour trip to Texas.
Why does the traction control light come on on my Jeep Rubicon?
I’m going through the same issue with my 2013 Rubicon. From time to time the traction control goes berserk and it feel like all of the power is transferred to the passenger side wheels resulting in the Jeep pulling hard to the left. It’s almost cause 2 collisions.
How to turn off the traction control light?
Remove the sensor, and you should see the tip covered in grime. Spray some brake cleaner on a rag, and then take the rag and wipe off the sensor tip. Re-install the wheel speed sensor, and test drive. As you drive down the road, the lights should go off and everything will be good to go.
Why is the traction control light on on my Jeep?
The iron particles from the brake disc can accumulate on the tip of the wheel speed sensor via magnetic attraction. Naturally, this does not occur right away, but rather, as the brake disc wears over time (e.g., 40k-50k miles).
Remove the sensor, and you should see the tip covered in grime. Spray some brake cleaner on a rag, and then take the rag and wipe off the sensor tip. Re-install the wheel speed sensor, and test drive. As you drive down the road, the lights should go off and everything will be good to go.
Why are the ABS and traction control lights on?
While driving today both the abs and traction control lights came on. I shut the vehicle off and restarted, it came back on again and when they are on I have no cruise control. I cleared codes using my procal but it doesn’t tell me what the codes are, after doing so the lights came back on again. Any idea what this is?