Why are the lights not working on my Renault Trafic?
This is a problem with the onboard management computer. It probably wasn’t reset by the mechanic when the new turbo was fitted. You’ll need to take it to someone with the correct diagnostic equipment to get this fault erased. Avoid Renault dealerships. They’ll charge anything from £80 to £400 to clear an error. Best find someone independent.
Why are my turn signal lights not working?
Changes in the flashing rate of the turn signal lights aren’t common and hard to notice as one of turn signal problems. In case this occurred after replacing the flasher or one of the light bulbs, you must have installed the wrong type of flasher or bulb for your vehicle model.
Why are the rear lights on my car not working?
The causes for dysfunctional rear lights are: 1 Burnt bulbs 2 Blown out fuse 3 Damaged wiring 4 Electrical issues
Why is the flasher not working on my Renault Fixya?
The flasher relay is the actual switch. You can’t post conmments that contain an email address. This is a problem with the onboard management computer. It probably wasn’t reset by the mechanic when the new turbo was fitted. You’ll need to take it to someone with the correct diagnostic equipment to get this fault erased. Avoid Renault dealerships.
This is a problem with the onboard management computer. It probably wasn’t reset by the mechanic when the new turbo was fitted. You’ll need to take it to someone with the correct diagnostic equipment to get this fault erased. Avoid Renault dealerships. They’ll charge anything from £80 to £400 to clear an error. Best find someone independent.
Why does my car think all the lights are working?
If all the bulbs are working it could be a bad earth making the car think a bulb has gone, get someone else to sit with their foot on the brake pedal whilst the indicator is on and see if the rear light clusters perform strangely (i.e. all lights flashing, or the ‘pulse’ of the indicator making other lights flash too).
What does it mean when your indicator light fails?
If the circuit tester illuminates, the wiring to and inside the switch are okay. If the circuit tester fails to light, it indicates a fault either in the switch itself or in the wiring between the switch and the multi-plug.
Why does my car indicator not cancel when I turn the wheel?
This is usually caused by wear in the cancelling peg attached to the inner moving column shaft. Not all cars use this system, so check. If the peg is a threaded metal one, you can adjust it by loosening its locknut then screwing it out a fraction at a time until the indicator switch cancels automatically when the wheel is turned.