Why are the dash gauges not working on my Holden Commodore?
Dash Gauges Not Working: Temp, Tacho Speedo and the Fuel Gauges. Temp, tacho speedo and the fuel gauges. They are siting on running in the middle but digital speedo works. My car is a Holden commodore vz. Also a pad lock light appears some times
Is the Tacho, Speedo, and temp gauge working?
Still no tacho, temp gauge or back lighting though. 1) joining pink wire to black wire gives no result/no dash lights. On a side note, joining black to blue/black makes sparks ha ha! 2) alternator warning light (I assume this is the one that looks like a battery) and the oil pressure warning light are functioning.
What to do if your dash gauges are not working?
I would check the fuses first here is a wiring diagram (BELOW) so you can do some testing for power and ground, Then remove the cluster and unplug it, then plug it back in again, this will fix it if it is a bad connection problem. Please run this test and get back to us so we can continue helping you.
Is the temp gauge on my Car working?
As stated in the thread title, my dash backlighting, speedo, tacho, and temp gauge are not working. However all of the warning lights and high beam indicator light work. The problem has me stumped, I have searched and searched here but haven’t found an answer yet.
Why does the speedometer and fuel gauge not work?
1. Speedo does not work (needle does not move while you’re riding)? 2. We’ve established the fuel level needle does not move 3. The low fuel light blinks. Everything else works fine (all lights, back lights). Could be 2 separate problems but they say coincidince takes a lot of planning.
Why is my speedometer stuck on my GM Silverado?
This section will outline all the most common problems that have been identified. The most common instrument cluster problem seen on the 03-06 GMs is faulty analog gauges. This is usually the first gauge problem the vehicle owner sees and is experienced as a stuck, sticky or jumpy gauge needle.
What should I do if my gas gauge stops working?
Gas gauge, almost empty. Water temp, cold. No oil pressure. The alt wasn’t charging. No tac and no speedometer. The Lights work fine, The odometer is still rollin over, cruise control works, Gear selection indicator read out works fine.. Any ideas?
Why is the green light on my speedometer not working?
If signal is coming from VSS, a SN74 is required and could be the cause of the speedometer not working. If a SN74 is being used, is the green light next to the dip on? If it is not on, then the SN74 is not getting power and won’t send a signal to speedometer.