Who are the manufacturers of Harley Davidson Road King turn signals?
All our Harley Road King turn signals are made by top brands like Kuryakyn, Arlen Ness, Custom Dynamics, J&P, Biker’s Choice, Drag Specialties, BikeMaster, and a whole bunch more. While you’re at jpcycles.com, check out all our Harley road king headlights.
Why is the blinker on my Harley Davidson not working?
If only one light (or one side) isn’t working, check the power to the bulb plug-in connections. With a voltmeter or test light, check the terminals for power. Check the battery for a full charge. Figure 1. Multimeter. Also consider what kind of work was recently done on the bike that might have affected the blinker system.
What to do if your blinker blinks too fast?
If you have blinkers that blink too fast, go to Step 4. When you are getting deeper into your troubleshooting project, give yourself plenty of time. Be careful not to disconnect other wiring while you are going through the harness.
How to install a load blinker on a Harley?
To install you take off saddle bag and side cover, or for mine had to pull off the seat and find the wiring harness that goes to the rear of the bike and unplug that harness and plug this into it! Very easy to do! This item did not resolve all the issues created from swapping incandescent turn signals to LED on my HD ’08 Road King.
Is the blinker light the same as the turn signal light?
If your setup has running lights with the turn signal, it’s important to know that these bulbs have a separate filament for the running light and signal light. One light is always on with the ignition, while the other is for blinker signal only.
Why are my blinkers not working on my bike?
Also consider what kind of work was recently done on the bike that might have affected the blinker system. For example, a connector may not have been pressed in all the way and disconnected itself from the vibration. If the fuses, connections and wiring looks okay, check the bulbs. Flashers work but turn signals don’t.
If you have blinkers that blink too fast, go to Step 4. When you are getting deeper into your troubleshooting project, give yourself plenty of time. Be careful not to disconnect other wiring while you are going through the harness.