Which is the front end of a balance shaft?
You can use the balance shaft’s front end since it has a larger diameter than the rear bearing. The left balance shaft bearing can be eliminated since the oil is fed through the shaft and not from the block. 5. Stub shaft install Use red Loctite or equivalent! Install the oil pump gears so that the timing mark are shown.
Are there any warning signs of balance shaft failure?
Common Warning Signs of Balance Shaft Failure Balance shaft failure is a common issue in Mercedes models equipped with the V6 piston engine, mainly the Mercedes M272, manufactured in 2004to 2008. Symptoms of a balance shaft failure are as follows:
How do you remove a balance shaft from a car?
1. Remove timing belt, downpipe, transfer case and oil pan. 2. Remove alternator, power steering pump, cross member, front and left motor mount to drop the engine low enough. 3. Remove the front case with the left balance shaft attached. This involves pulling the crank shaft sprocket and everything else over the front case. 4.
Is the drive shaft balanced with the rear diff?
The drive shaft is balanced as a unit, it is not balanced with the trans or the rear diff. What you do have to consider is the “clocking” of the u-joints. If you drive shaft is such that removing it can change the relationship between the u-joints, then your method of resolving your viberation issue should work.
What does the balance shaft do in a Mercedes?
The balance shaft gearis responsible for helping to balance out engine componentsand prevent harmful vibrationsat high speeds and when shifting gears. It does this by acting as a counterweight to these engine components as the vehicle accelerates, keeping them as still and secure as possible.
Common Warning Signs of Balance Shaft Failure Balance shaft failure is a common issue in Mercedes models equipped with the V6 piston engine, mainly the Mercedes M272, manufactured in 2004to 2008. Symptoms of a balance shaft failure are as follows:
Where is the oil hole on a balance shaft?
You can see the bearing oil hole is now to the left. NOTE: Install the rear first. You can use the balance shaft’s front end since it has a larger diameter than the rear bearing. The left balance shaft bearing can be eliminated since the oil is fed through the shaft and not from the block.
Which is the correct way to install a balance shaft?
Install the bearings flipped 180 degrees at the vertical axis to block off the oil hole. You can see the bearing oil hole is now to the left. NOTE: Install the rear first.