Where was Jeep Commander Automatic Transmission Control Module replaced?
The vehicle was taken to bosak Jeep (3111 w. Lincoln hwy merrillville, in 46410) and an unknown relay switch was replaced however, the failure continued. The mechanic then informed the contact that the crankshaft sensor, camshaft sensor, and power train control module were defective and needed to be replaced.
Are there any problems with the Jeep Commander?
Jeep Commander owners have reported 90 problems related to automatic transmission control module (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Jeep Commander based on all problems reported for the Commander.
What kind of PCM does a Jeep Commander have?
The contact owns a 2007 Jeep Commander. While driving 45 mph, the vehicle lost power and the check engine warning light illuminated. The vehicle was taken to multiple dealers and the mechanics diagnosed that the pcm needed to be replaced. The failure recurred on numerous occasions.
Why does my Jeep Commander go in neutral?
The tcm on this vehicle goes in neutral when you are driving use 3 different Jeep Commander and all have the same issue report it to the dealer and they told me is the tcm malfunction. Driving under certain conditions the vehicle engine completely shuts off and stalls. This happens on the highway, mostly at speeds of about 45-60 mph.
Why is my Jeep Commander not shifting gears?
I was getting engine codes U0404 & P0700 on my 2006 Jeep Commander 3.7 caused by the electronic shift module sending mixed signals to the computer. The auto-stick manual gear select wasn’t working at all in my Jeep. I installed the replacement shift module and the auto-stick works perfectly and the engine codes never returned.
The vehicle was taken to bosak Jeep (3111 w. Lincoln hwy merrillville, in 46410) and an unknown relay switch was replaced however, the failure continued. The mechanic then informed the contact that the crankshaft sensor, camshaft sensor, and power train control module were defective and needed to be replaced.
Can a PCM cause a Jeep Commander to crash?
The powertrain control module (pcm) was programmed with software that may allow the engine to stall under certain operating conditions. Consequence: this could cause a crash without warning. What owners should dealers will reprogram the pcm software in all 4. 7l engine equipped my 2006 Jeep Commanders built prior to January 11, 2006.
What does trouble code mean on Jeep Commander?
A trouble code is a code thrown out by an automatic transmission whenever it detects in the Commander that there is an issue that needs your attention. In the case of the P0700, it is a general code. This means that it should be accompanied by some other code that should tell you the specific problem.