Where is the tilt lever on a CJ5 Ididit?
After removing all items from the package, screw the knobs onto the levers. The tilt lever is installed on the left side of the column in the threaded hole closest to the dash. We recommend using Locktite. Turn Signal Lever: The turn signal lever is inserted into the hole closest to the top of the column.
Where is the flat plug on a CJ5 Ididit?
Loosen and remove the bolt on the u-joint that holds the column to the intermediate shaft with an 11/16” socket. (Figure 1) Remove the 4 screws that hold the dash cover. Slide this cover up the column and secure with a piece of tape. (Figure 2) Locate the flat plug on the passenger side of the column located at about 3 o’clock.
How do you install a column on a CJ5 Ididit?
Slide the original dash cover onto the new ididit column. Then install the dash mount with the new bolts provided. Note: The mount should have the rounded corners facing the bottom of the column. These bolts should be torqued to 22 ft. lbs. (Figures 10 & 11) Slip the column through the dash and install the floor mount and gasket over the column.
What to do when column hangs up on CJ5?
If the column hangs up, the helper can pry the u-joint open slightly with a #2 regular screwdriver, releasing it from the column. Caution should be used while removing the column through the dash as there are lots of items that will catch on the dash. Keep wires clear and (Figure 4) (Figure 5) (Figure 6) (Figure 7)
After removing all items from the package, screw the knobs onto the levers. The tilt lever is installed on the left side of the column in the threaded hole closest to the dash. We recommend using Locktite. Turn Signal Lever: The turn signal lever is inserted into the hole closest to the top of the column.
Loosen and remove the bolt on the u-joint that holds the column to the intermediate shaft with an 11/16” socket. (Figure 1) Remove the 4 screws that hold the dash cover. Slide this cover up the column and secure with a piece of tape. (Figure 2) Locate the flat plug on the passenger side of the column located at about 3 o’clock.
If the column hangs up, the helper can pry the u-joint open slightly with a #2 regular screwdriver, releasing it from the column. Caution should be used while removing the column through the dash as there are lots of items that will catch on the dash. Keep wires clear and (Figure 4) (Figure 5) (Figure 6) (Figure 7)
Slide the original dash cover onto the new ididit column. Then install the dash mount with the new bolts provided. Note: The mount should have the rounded corners facing the bottom of the column. These bolts should be torqued to 22 ft. lbs. (Figures 10 & 11) Slip the column through the dash and install the floor mount and gasket over the column.