Where is the throttle position sensor on a Ford Ranger?
Your Ford Ranger uses a series of complex sensors to report what is going on to the ECU. The ECU then uses this information to adjust the timing, air fuel mixture, and more. When one of them goes wrong, it can lead to stalling for sure. Throttle Position Sensor – The throttle position sensor is typically located on the gas pedal.
Why is my Ford Ranger stalling at stoplights?
A dirty throttle body can lead to stalling in your Ranger. If you let off of the gas coming to a stoplight and it stalls for a second or two and recovers itself, it very well could be a dirty throttle body that is causing the problem. Here’s a great YouTube video from EricTheCarGuy. on how to clean a throttle body.
Why does my Dodge Avenger stall when I push the gas?
VVT Problem – Many modern engines are equipped with Variable Valve Timing. This allows for the engine to be in the “sweet spot” of power or economy depending on how hard you are pushing the gas pedal. If there is a VVT issue, it’ll often throw trouble P0010, P0011, or other related trouble codes. This is often the cause of the stalling.
What to do if your EFI machine is sputtering?
You can also (with the machine off), grab the coil and see if you can rotate it….if you can rotate it, then the ground, mount bolt is loose and needs to be tightened. In order to tighten, you need to remove the two bolts on the mount plate. They screw directly in to the frame.
What kind of fuel pump does sniper EFI need?
Fuel System Requirements The Sniper EFI system requires a high pressure fuel pump capable of operating at 60 psi with at least 50 gallon per hour of fuel flow (more fuel flow may be needed for higher horsepower engines). When selecting a pump, and lines, be sure each component is designed to perform at high pressure.
How to install the EFI on a sniper?
Place the Sniper EFI throttle body on top of the new flange gasket on the manifold. Install the hold down nuts and snug down progressively in a “criss-cross” pattern (60-80 in./lbs.). Depending on your application, this is also the time to install your throttle bracket and transmission kickdown brackets.
How big should the Bung be on sniper EFI?
This bung location needs to be verified before using it with the Oxygen sensor included in the Sniper EFI system. Ideally the bung will be 6-10 inches after the collector for a true reading of all cylinders and have a minimum of 18” length past the sensor location.
You can also (with the machine off), grab the coil and see if you can rotate it….if you can rotate it, then the ground, mount bolt is loose and needs to be tightened. In order to tighten, you need to remove the two bolts on the mount plate. They screw directly in to the frame.