Where is the thermostat on a Harley Davidson?
The thermostat and pump are housed beneath a plastic cover, below the voltage regulator. Remove the cover to visually inspect. Make sure there are no leaks from components or any of the corresponding hoses. Clean and reinstall this cover. Where’s the Tank?
How do you turn off the coolant pump on a Harley Davidson?
The coolant pump and fans will begin to run. The system is now in bleed mode. You can release the throttle. With the pump running, continue to add Harley coolant until the system is completely topped off. Turning off the ignition switch will stop the pump and fan from operating.
Where is the cooling system on a Harley Davidson?
Harley-Davidson Liquid Cooled Service. This system is very similar to an automotive cooling system.It consists of two radiators, located in the motorcycle’s right and left side lower fairings. It has fans, a thermostat, expansion tank, pressure cap, a pump and input/output hoses.The cooling system pumps coolant around the motor’s exhaust valves,…
How can I check the coolant level on my Harley?
The coolant level has to be checked cold, on the jiffy stand.Do not remove the pressure cap as it is not part of regular maintenance. Only a visual inspection is needed. Clean the plastic cover and carefully reinstall. It is also important to visually inspect coolant lines/hoses at the cylinder heads.
The thermostat and pump are housed beneath a plastic cover, below the voltage regulator. Remove the cover to visually inspect. Make sure there are no leaks from components or any of the corresponding hoses. Clean and reinstall this cover. Where’s the Tank?
Harley-Davidson Liquid Cooled Service. This system is very similar to an automotive cooling system.It consists of two radiators, located in the motorcycle’s right and left side lower fairings. It has fans, a thermostat, expansion tank, pressure cap, a pump and input/output hoses.The cooling system pumps coolant around the motor’s exhaust valves,…
How do you fix a liquid cooled Harley Davidson?
Use a non marring tool to remove the plastic radiator grate.Compressed air should be used to clean, both, the grate and the radiator fins on the left and right sides. Reinstall the grate. The thermostat and pump are housed beneath a plastic cover, below the voltage regulator. Remove the cover to visually inspect.
The coolant level has to be checked cold, on the jiffy stand.Do not remove the pressure cap as it is not part of regular maintenance. Only a visual inspection is needed. Clean the plastic cover and carefully reinstall. It is also important to visually inspect coolant lines/hoses at the cylinder heads.