Where is the thermostat on a 2008 Kia?
The thermostat in the 2008 Kia Sorento is located at the point where the radiator hose connects to the engine. This component regulates the flow of coolant for the engine.
How much does a thermostat cost for a 2007 Kia Sportage?
2007 Kia Sportage Thermostat – from $13.99+ | AutoZone.com.
Where is the thermostat on a Kia Sportage?
It is on the back of the head and the housing has an elbow that points to the left side of the engine. It is in a less than accessible area, but can be done.
Why does my Kia Sportage keep overheating?
2000 kia sportage: overheating..water pump..Radiator does NOT leak. my 2000 kia sportage keeps overheating. I have replaced the thermostat, checked the water pump (it’s good).
Where is the thermostat on a Kia Rio?
Use the pliers to remove the clamp from the upper radiator hose connecting to the thermostat cover, located on the passenger side of the Kia Rio engine bay. Cover the opening of the hose to prevent contaminants from entering your cooling lines. Remove the bolt from the thermostat cover, then set the cover aside.
How do you change the thermostat on a Kia Sedona?
Make sure to use a drain pan to catch all of the antifreeze as it drains from the radiator. Remove the engine cover. On the Kia Sedona, it’s the large, gray composite piece that sits right in the top center of the motor. Use the appropriate screwdriver (such as a Phillips) to remove the six screws that hold the cover. Take off the air intake.
Why is my Kia thermostat still in place?
The thermostat may be held in place because of vacuum, and the pliers give you the necessary leverage to twist it a bit to pull it loose. Replace the old unit with your new thermostat and gasket. Once installation is complete, put all of the engine parts you’ve removed back in place by reversing the steps above.
2000 kia sportage: overheating..water pump..Radiator does NOT leak. my 2000 kia sportage keeps overheating. I have replaced the thermostat, checked the water pump (it’s good).
Make sure to use a drain pan to catch all of the antifreeze as it drains from the radiator. Remove the engine cover. On the Kia Sedona, it’s the large, gray composite piece that sits right in the top center of the motor. Use the appropriate screwdriver (such as a Phillips) to remove the six screws that hold the cover. Take off the air intake.
Use the pliers to remove the clamp from the upper radiator hose connecting to the thermostat cover, located on the passenger side of the Kia Rio engine bay. Cover the opening of the hose to prevent contaminants from entering your cooling lines. Remove the bolt from the thermostat cover, then set the cover aside.