Where is the starter clutch assembly on a Harley Davidson?
Disassemble the nose of the starter. The starter clutch assembly will be located in the nose assembly at the top left in this photo; in most cases, it should pull right out with its bearing. The picture below shows how it looks when removed. Set it aside, as this is the piece that will be replaced. Figure 6. Starter clutch assembly.
Why does the starter disengage on a Harley Davidson?
When the engine is running, the clutch disengages to avoid the engine back-driving the starter, protecting it from damage. It’s likely this one-way clutch is the culprit if your starter is noisy or spins without turning the motor. In this article we’ll show you how to replace the starter clutch.
What is the one way clutch on a Harley Davidson?
In order to protect the starter motor, the systems are equipped with a one-way clutch. This clutch grips the starter driveshaft, which is in turn engaged to the flywheel inside the primary cover to turn the engine. When the engine is running, the clutch disengages to avoid the engine back-driving the starter, protecting it from damage.
When do you need to replace the starter on a Harley Davidson?
If your Harley big twin starter is making unusual sounds or just spinning, you probably need to replace the starter clutch. This article applies to Harley Davidson big twins (2006-2016).
How much does it cost to replace a starter clutch on a Harley?
This starter clutch, however, will cost us a little more than its predecessor. How long it takes to replace your Harley starter clutch will simply depend on what model HD you own. Once the starter is on the bench, it is a quick, easy process to separate the gear housing section of the starter from the motor and solenoid sections.
Is the starter clutch the same as the starter gear?
Prior to 2007, the starter clutch and the starter gear were two separate parts. Harley has since changed the design. Now the Harley starter clutch and gear are one component within the starter and swapping one out is easier than ever.
How do you replace a starter on a Harley Davidson?
Harley Starter Clutch Replacement. Once the starter is on the bench, it is a quick, easy process to separate the gear housing section of the starter from the motor and solenoid sections. The clutch assembly is held in with only a light, press fit. An internal o- ring assists in keeping it aligned, properly orientated, and sealed within the housing.
Why is my starter clutch leaking on my Harley?
The clutch assembly is held in with only a light, press fit. An internal o- ring assists in keeping it aligned, properly orientated, and sealed within the housing. We have had customers tell us “my starter is leaking”.