Where is the speed sensor located on a 2002 Honda Civic?
The vehicle speed sensor is located on the top of the transmission close to the back.
How do I find out how many miles my Honda Civic has?
Press the (TRIP) knob to change the display. Shows the total number of miles or kilometers that your vehicle has accumulated. Shows the total number of miles or kilometers driven since the last reset.
Where is the speedometer located on a Honda Civic?
The vehicle speed sensor (VSS) gear is located on the transmission, and it sends an RPM signal to the engine control unit (ECU). The ECU then translates this signal into MPH, and relays that information to the speedometer in your car’s instrument panel.
Where is the oxygen sensor located in a Honda Civic?
In 1996, a second generation of vehicle On-Board Diagnostic (OBD-II) computers were introduced in the United States and the use of two oxygen sensors was required. The Primary Oxygen (PHO2) sensor is placed between the catalytic converter and the exhaust system.
What causes a Honda Civic speedometer to stutter?
If one or both oxygen sensors malfunction, incorrect ignition and fuel supply could cause the engine to run poorly, which will cause the speedometer to jerk and stutter in response. A bad oxygen sensor is often accompanied by the check engine light.
What to do if your Honda speed sensor is broken?
If your ’98 – ’02 Honda Accord speedometer is performing erratically, or not at all, your vehicle speed sensor may be damaged or broken. Use this guide to replace your damaged vehicle speed sensor. Pull on the hood release lever just inside the passenger door to pop the hood.
The vehicle speed sensor (VSS) gear is located on the transmission, and it sends an RPM signal to the engine control unit (ECU). The ECU then translates this signal into MPH, and relays that information to the speedometer in your car’s instrument panel.
Where is the fuse box on a Honda Civic?
Every Honda Civic has a fuse box, which is located on the inside of the dashboard on the driver’s side. If the fuse that controls the speedometer comes loose or blows, the speedometer may behave erratically, or stop functioning entirely.
How do you replace a speedometer on a Honda?
Undo several clips on both sides of the dashboard bezel, and remove it. Use a 1/4” ratchet, socket and extension to remove the wiring cluster from the dashboard. Unplug the harness from the gauge cluster. Plug the stock harness into the replacement gauge cluster/speedometer. Use the 1/4” ratchet, socket and extension to install the new cluster.
If one or both oxygen sensors malfunction, incorrect ignition and fuel supply could cause the engine to run poorly, which will cause the speedometer to jerk and stutter in response. A bad oxygen sensor is often accompanied by the check engine light.