Where is the reference window on a Sprocket Rocket?
Remove the camera’s back door by lifting the backdoor closures on both sides of the camera. Turn the sprocket gear until you see the white dot in the film-stopping reference window which is located on the top of the camera, just to the left of the viewfinder and hot-shoe.
Where is the white dot on the sprocket?
Turn the sprocket gear until you see the white dot in the film-stopping reference window which is located on the top of the camera, just to the left of the viewfinder and hot-shoe. Pull upwards to lift the rewinding knob, insert a fresh roll of film, then push the rewinding knob back down, locking the film in place.
How many exposures does a Sprocket Rocket take?
A standard film of 35mm, which normally yields 36 exposures, will produce 18 super-wide angle shots on the Sprocket Rocket. Turn the rewinding knob in the direction of the arrow to rewind your film. When the knob suddenly feels very loose and the tension is no longer there it means your film has been completely rewound.
What should I do to my sprocket rollers?
Clean and polish the sprocket roller driving surface with fine Emery cloth. Now turn your attention to the back of the rotor. Inside the back you will see three rollers and three guide pins with springs inside them. Remove and wash them, then check the rollers for flats.
How do I connect my hp sprocket to my printer?
Use Bluetooth® to connect to your printer. Make sure the viewfinder is closed, Bluetooth® is active, and the printer is on. The HP Sprocket app will help you pair during the in-app setup instructions. If you have already set up your printer, open the Main Menu, tap “sprocket”, then choose “Manage Printers” and tap “Add New Printer”.
What should I do if my starter is not working?
The starter pinion gear engages this wheel to make your car engine crank. Remove the starter motor and set your transmission gear to neutral. Rotate the crankshaft manually using a ratchet. There is a pulley at the front or bottom of your engine block. The pulley should move as you watch how the pion gears are reacting.
What should I do if I slip my starter clutch?
The rotor should then pull off the shaft but it may be extremely tight on its splines and require a puller to get it off. With the rotor removed, the driven sprocket is exposed. It comes off together with the starter chain and starter sprocket. Wash the needle roller bearing out and clear the oil holes.