Where is the purge valve located on a 2016 Hyundai Santa Fe?
The purge valve is located at the back on the engine on the intake manifold (not easy to get to).
How to remove battery from Hyundai Santa Fe?
Open the tailgate. 2. Find the plastic hex bolt cover and remove the cover with coin or flathead Removal 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the front wheels can face straight ahead.
What are the components of a Hyundai Santa Fe?
Variable Intake Solenoid (VIS) Valve 23. Fuel Pressure Regulator Valve 24. Canister Close Valve (CCV) 25. Ignition Coil 26. Main Relay 27. Fuel Pump Relay 28. Data Link Connector (DLC) [16-Pin] 29. Multi-Purpose Check Connector [20-Pin] 1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3.
Where is the spare tire located in a Hyundai Santa Fe?
Your spare tire is stored underneath your vehicle, directly below the cargo area. To remove the spare tire: 1. Open the tailgate. 2. Find the plastic hex bolt cover and remove the cover with coin or flathead Removal 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
Where are the ignition coils on a Hyundai Santa Fe?
Schematic Diagrams ECM Terminal And Input/Output signal ECM Terminal Function Connector [C100-A] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output [NON-smart key type] Ignition Coil (Cylinder (Option/accessory.)
What causes purge valve to fail on Hyundai Santa Fe?
When it fails, the purge valve will no longer be able to operate properly. When this happens P0441 will almost always throw. Bad Vacuum Line – If the vacuum line going to the purge canister has failed, that’ll cause the P0441 code to show up for sure. This is worth taking a look at especially if you live in a drier climate.
What causes the p0441 trouble code on a Hyundai Santa Fe?
EVAP Canister Purge Valve – The most common issue that causes the P0441 trouble code in your Hyundai Santa Fe is going to be the vapor canister purge valve. When it goes bad, it typically causes issues with the vehicle’s idle speed. This is especially true right after you fuel up. It’s really easy to replace.
What causes Hyundai Santa Fe to fail emissions test?
The Santa Fe’s ECM will trigger this code when it detects that the vacuum level in the Purge System is not within the proper specifications. P0441 can cause the vehicle to fail an emissions test.
When to replace fuel cap on Hyundai Santa Fe?
If you are getting a message to tighten your fuel cap when it is tightened already, you should replace the fuel cap before doing anything. They are afHyundaiable, and easy to replace. Wiring Issue to the Purge Solenoid – Due to the location of the purge solenoid, it is not uncommon for the wiring going to it to fail.