Where is the oil filter on a Porsche 911 Carrera?
The 911 Carrera filter is a cartridge-type filter, which is contained within a plastic oil filter housing next to the bottom sump underneath the car. You will typically need the factory oil filter housing removal tool, or a comparable one, in order to remove the housing. Remove the plastic housing, and underneath you will see the cartridge filter.
How to change the oil in a Porsche 911?
Wayne R. Dempsey Figure 1 Some car came equipped with a protective Figure 2 The filter housing will probably be stuc Figure 3 Be sure to remember to replace the large Figure 4 Take the filter and push it up onto the Figure 5 Fill your car with oil from the inlet in
Where is the drain plug on a Porsche 911?
In a similar manner to the oil tank, remove this plug, and empty the oil into your oil pan. The bottom of the engine sump will contain significantly less oil than in the oil in the tank. Starting in late 1983, Porsche moved the location of this drain plug from the bottom of the engine to the side of the case.
Why are the oil return tubes on my Porsche 911 leaking?
Many times, replacing this spring fixes the problem. The oil return tubes on the 911 engine are prone to leaking after many years of heat cycling. In this article, we show you how to replace them without removing the engine from the car. One of the most popular upgrades for the 911 is the addition or upgrade of the external oil cooler.
How do you get the oil filter off a Porsche 911?
One sure-fired way to get the oil filter off is to poke a hole in one side of it and out the other with a long screwdriver. Using the handle of the screwdriver gives you the leverage that you need to remove the filter. It doesn’t matter that you are destroying the filter, because you are going to be installing a new one.
In a similar manner to the oil tank, remove this plug, and empty the oil into your oil pan. The bottom of the engine sump will contain significantly less oil than in the oil in the tank. Starting in late 1983, Porsche moved the location of this drain plug from the bottom of the engine to the side of the case.
How to check oil level in Porsche 911?
The oil level can only be checked with the engine running at idle and at operating temperature. If the oil level is low, then add more oil while the engine is running. One to two quarts of oil added to the tank will make the oil level on the dipstick rise from the low mark to the high mark.
How to install spin on oil filter adapter?
When installing, be sure to lubricate both o-rings with clean engine oil. Do not pre-fill the oil filter with oil. Screw the oil filter adapter onto the engine by hand. Once the spin on filter adapter is fully engaged to the block, use a 26mm socket and torque to 25 Nm (18 Ft/Lbs).
Is there an oil filter on a Porsche 993?
There are two oil filter in the 993 engine, Porsche added an additional oil filter on the 993 engine to provide extra filtration of the oil for the protection of the hydraulic lifters. (1). Jack your car up on 4 jack stands, please refer to “How to jack your car up” section for details. Remove the right rear wheel. (2).
What kind of oil does a Porsche Carrera use?
Heavier-weight oils protect well against heat; lighter-weight oils flow better in cold. In general, if you live in a cold climate, you should use a 10W-40 or similar oil. This oil is a 10-weight oil that behaves and protects against heat like a 40-weight oil. In warmer climates, you should use a 20W-50 oil.
The 911 Carrera filter is a cartridge-type filter, which is contained within a plastic oil filter housing next to the bottom sump underneath the car. You will typically need the factory oil filter housing removal tool, or a comparable one, in order to remove the housing. Remove the plastic housing, and underneath you will see the cartridge filter.
What do I need for an oil change on a Porsche 993?
Some of the most important tools and items needed for this DIY is a oil filter socket, and over sized drain pan. There are two oil filter in the 993 engine, Porsche added an additional oil filter on the 993 engine to provide extra filtration of the oil for the protection of the hydraulic lifters.
Heavier-weight oils protect well against heat; lighter-weight oils flow better in cold. In general, if you live in a cold climate, you should use a 10W-40 or similar oil. This oil is a 10-weight oil that behaves and protects against heat like a 40-weight oil. In warmer climates, you should use a 20W-50 oil.
Why do I need to remove the oil filter from my Porsche Boxster?
You want to make sure that you remove the filter with the oil pan still under the car because the oil filter is full of oil, and this oil will have a tendency to drip down out of the filter into the engine and out the drain hole.
There are two oil filter in the 993 engine, Porsche added an additional oil filter on the 993 engine to provide extra filtration of the oil for the protection of the hydraulic lifters. (1). Jack your car up on 4 jack stands, please refer to “How to jack your car up” section for details. Remove the right rear wheel. (2).