Where is the oil filter on a Jeep Cherokee?
It’s the white canister located on the passenger side of the 4.0L engine, just behind the motor mount and beside the distributor. Your motor mounts won’t look like mine (with Rusty’s sticker) unless they’ve been swapped. Also, various brands of oil filters come in different colors.
How to change the oil in a Jeep Cherokee?
DO NOT BE AN IDIOT BY DUMPING USED OIL IN STORM DRAINS OR ANYWHERE ELSE! Wipe off the oil pan with a rag & crawl back out. Remove filler cap from valve cover and insert CLEAN funnel insuring that it will remain in place while pouring oil.
What kind of oil should I put in my Jeep XJ?
As usual, a basic set of tools along with some shop towels and a big piece of cardboard to slide up under the XJ to catch any spillage. 6 quarts of quality oil. I prefer Havoline oil myself but the arguements are many for all the various brands. Using synthetic is asking for trouble!
How to change the oil on a Jeep Wrangler?
. Save money by changing your own oil with Trailhead Tools speciality wrench designed specifically for changing your Jeep Wrangler’s Oil. 24mm with the proper angle to reach the filter cap on one end and the 13mm for the drain plug on the other. Batteries Included? Batteries Required?
What kind of drain plug does a Jeep Cherokee use?
XJ – Transfer Case Drain Plug Type: Bolt Head: Hexagon 20 240 27.12 XJ – MANUAL Transmission Drain Plug Type: Bolt Head: Hexagon Drive Shaft To Transfer Case Assembly 22 264 29.83 XJ – Driveshaft to Transfer Case Flange Bolts Type: Bolt Head: Hexagon Drive Shaft To Transfer Case Assembly 35 420 47.45 XJ – FRONT Universal Joint Flange Nut Type:
Can you remove the oil filter on a Jeep JK 3.6?
The tool does not clear any of the surrounding areas of the oil filter on the Jeep JK 3.6. So you can not get a full or even half turn. It would take forever to remove the filter. You would be better off with a socket and extension. The oil pan drain plug side works ok. All I got was the cardboard.
How to test fuel pump in Jeep Cherokee?
Use a circuit tester and test the harness side for power as your helper turns the key on and off. Remember that there will be power for only 2 seconds, so have your helper cycle the key on and off as you check the terminals, allowing 5 seconds between cycling for the computer to reset.