Where is the mixture screw on a Harley CV carburetor?
The CV style Harley carburetor has a small cylindrical tower protruding from the bottom rear of the spigot (behind the bowl). The tower is plugged with a soft metal insert covering the mixture screw. Gaining access to this screw is key to fine tuning and must be remove.
Why is my Harley CV carburetor stalling after tuning?
Hesitation or stalling can sometimes occur after tuning or rebuilding your Harley CV carburetor or if your Harley carb has not been maintained. The following are common issues sometimes encountered after tuning or rebuilding a Harley CV carburetor.
How can you tell if a Harley Davidson carburetor is right?
Blip the throttle a couple of times and observe the results. If the engine responds quickly with a smooth blast and no backfiring through the carburetor, you have your idle mixture right. If backfiring occurs through the carburetor then adjust the idle mixture screw out another 1/8 turn.
When to start a Harley Davidson CV carburetor?
The mixture screw or EZ-Just is the key to proper tuning. These tuning steps apply to all Harley CV carbs from 1989 to present that use the CV 40mm style Harley Davidson carburetor but also apply to the CVK40 found on other models. Always start with a fresh set of spark plugs when tuning.
The CV style Harley carburetor has a small cylindrical tower protruding from the bottom rear of the spigot (behind the bowl). The tower is plugged with a soft metal insert covering the mixture screw. Gaining access to this screw is key to fine tuning and must be remove.
When to tune a Harley Davidson CV carburetor?
These tuning steps apply to all Harley CV carbs from 1989 to present that use the CV 40mm style Harley Davidson carburetor but also apply to the CVK40 found on other models. Always start with a fresh set of spark plugs when tuning. The carburetor will need to be removed from the manifold so refer to your factory shop manual for this procedure.
When to use mixture screw on Harley Davidson cvk40?
The mixture screw or EZ-Just is the key to proper tuning. These tuning steps apply to all Harley CV carbs from 1989 to present that use the CV 40mm style Harley Davidson carburetor but also apply to the CVK40 found on other models.
Why is my CV carb not working on my Harley?
Again it should be emphasized, the #1 cause of carburetor related problems on a Harley or other V-Twin motorcycle is VACUUM LEAKS. The CV carb is dependent upon vacuum to function properly. 2) Check that the Needle Jet (nozzle) is installed correctly.