Where is the heater motor resistor on a Jeep XJ Sport?
Please try again later. How to repair and replace the Heater Blower Motor Resistor on a 1997 – 2001 Jeep Cherokee XJ Sport 2.5 Diesel. In this video you can see how to replace the Heater Blower Motor resistor, which is located behind the glove box. If you loose the fan speeds 1 -3 and only have speed 4 on the fan, this is what you do.
Where is the E-Fan on a Jeep Cherokee?
The e-fan is on the same side of the engine compartment as the intake/exhaust manifolds and fuel rail and injectors. When the engine is shut-off, the e-fan time delay will cause the fan to blow air over the manifolds and out the back end of the engine compartment and will prevent the fuel rail and injectors from getting quite so hot.
What should I do about my Jeep XJ heat soak?
This article is specific to a 2000-2001 Jeep Cherokee XJ but the mod described should be pretty easy to adapt to other years of XJ’s with or without a Power Distribution Center (PDC).
Where is the motor resistor on a Jeep Cherokee?
In this video you can see how to replace the Heater Blower Motor resistor, which is located behind the glove box. If you loose the fan speeds 1 -3 and only have speed 4 on the fan, this is what you do. You will need a small socket set and a philips screwdriver. Loading…
Where is the fan on a Jeep Wrangler?
This is the guy in charge of blowing air across the hot heater core, through the Jeep’s ventilation system, and into the cabin. The fan is usually located behind the glove box and when it fails, you may still get cold or warm air through the vents, but it will be at a drastically lower pressure no matter what fan speed you select.
What to do if your Jeep Wrangler heater is not working?
So it may be beneficial for those with newer Jeeps to take a spin to the dealership, or trusted mechanic, for a diagnosis. This is the guy in charge of blowing air across the hot heater core, through the Jeep’s ventilation system, and into the cabin.
Is it possible to replace a Jeep Cherokee heater core?
Yep every Jeep XJ Cherokee owner has to face it sooner or later, your on your way someplace in your XJ, it’s kinda cold and your heater just isn’t blowing hot air like it should. In this video I show you what it could possibly be. Also it’s alot easier than replacing a heater core. Loading…
This article is specific to a 2000-2001 Jeep Cherokee XJ but the mod described should be pretty easy to adapt to other years of XJ’s with or without a Power Distribution Center (PDC).
Where is the blower motor adapter on a Jeep Grand Cherokee?
The blower motor adapter is a bundle of three wires located on the left side. While the vehicle’s ignition is on, push and pull gently on the wire connection. If the blower motor turns on, you have identified the problem and following this guide will help you fix it
What to do if your Jeep Grand Cherokee fan does not turn on?
If the fan does not turn on, the damage may not be fixable without purchasing new parts. For your safety do not grasp any wires you can not see. Do not attempt to grasp any wires that are not covered in insulation and/or electrical tape. Turn off the ignition on the vehicle and proceed with the following steps.
How to fix AC and heater in 1999 Jeep Grand Cherokee?
Clarify it by editing! The 1999-2004 Jeep Grand Cherokee has a common failure where the blower fan wire adapter overheats and melts. Use this guide to fix and repair this connector and get your AC and Heater working again! No parts specified. Place the car in park, activate the parking brake, and leave the car running.
How does the Jeep Cherokee a / C heater motor work?
A Jeep Cherokee A/C blower motor is a vital part of your Jeep’s HVAC system. The blower motor resistor controls the speed of your fan (blower motor). When the fan works at high speed, but not in some lower speeds, this is frequently a result of a faulty resistor.
The blower motor adapter is a bundle of three wires located on the left side. While the vehicle’s ignition is on, push and pull gently on the wire connection. If the blower motor turns on, you have identified the problem and following this guide will help you fix it
If the fan does not turn on, the damage may not be fixable without purchasing new parts. For your safety do not grasp any wires you can not see. Do not attempt to grasp any wires that are not covered in insulation and/or electrical tape. Turn off the ignition on the vehicle and proceed with the following steps.
Clarify it by editing! The 1999-2004 Jeep Grand Cherokee has a common failure where the blower fan wire adapter overheats and melts. Use this guide to fix and repair this connector and get your AC and Heater working again! No parts specified. Place the car in park, activate the parking brake, and leave the car running.
Why does my Jeep Grand Cherokee Fan quit working?
In this one we take a stab at permanently fixing a common issue with the 1999-2004 Jeep Grand Cherokee. The electric cooling fan will quit working, and your jeep will overheat, due to a failure in the electronic fan control relay. This is a heat related failure and I add a large heat sink and relocate the relay to try and avoid further issues.
Where is the blower Motot relay on a 1998 Jeep Gran Cherokee?
Where is the blower motot… Where is the blower motot relay on a 1998 Jeep Gran Cherokee Submitted:12 years ago. Category: Jeep Show More Show Less Ask Your Own Jeep Question Share this conversation Answered in 6 minutes by: 11/26/2008 Jeep Mechanic: Jerry, Master Mechanic replied 12 years ago Jerry, Master Mechanic Category: Jeep
Please try again later. How to repair and replace the Heater Blower Motor Resistor on a 1997 – 2001 Jeep Cherokee XJ Sport 2.5 Diesel. In this video you can see how to replace the Heater Blower Motor resistor, which is located behind the glove box. If you loose the fan speeds 1 -3 and only have speed 4 on the fan, this is what you do.
In this one we take a stab at permanently fixing a common issue with the 1999-2004 Jeep Grand Cherokee. The electric cooling fan will quit working, and your jeep will overheat, due to a failure in the electronic fan control relay. This is a heat related failure and I add a large heat sink and relocate the relay to try and avoid further issues.
Where is the blower motot… Where is the blower motot relay on a 1998 Jeep Gran Cherokee Submitted:12 years ago. Category: Jeep Show More Show Less Ask Your Own Jeep Question Share this conversation Answered in 6 minutes by: 11/26/2008 Jeep Mechanic: Jerry, Master Mechanic replied 12 years ago Jerry, Master Mechanic Category: Jeep
How to draw a wiring diagram for a jeep heater?
Since you did have melting at the mode switch, a common problem, & replaced the connector with 3 individual wires make sure the wires are in the correct positions. Smaller light green wire on top, larger dark green wire in the middle & black on the bottom.