Where is the governor on a scooter?
Your scooter’s rev limiter prevents its engine from transferring all of its energy to the drive belt. It is located in your scooter’s drive belt or variator system on the left side of the scooter.
How can I make my Kymco scooter faster?
Making a derestricted scooter go faster
- Use a larger carburetor and/or larger jets.
- Use a more free flowing air filter.
- Use a more free flowing exhaust system.
- Install a cylinder head with larger/more valves.
How to remove the governor for a 50cc Honda Metro scooter?
Removing the governor of your 50 cc Honda Metro scooter will certainly increase its speed, and it may even enable it to travel fast enough that you may need to reregister the vehicle as a larger class motorcycle. Pull out the pin attaching the kickstart to the variator case of your Honda Metro.
How do you remove Governor from Honda variator?
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.
How do you derestrict a Honda Metropolitan scooter?
In order to access this washer and thus derestrict your Honda Metropolitan, you must disassemble the variator system using various wrenches. Take your Metropolitan’s kickstand off. The kickstand is secured with a small pin that must be loosened with a socket wrench before you can pull it out and remove the kickstand.
How do you remove Kickstart from Honda Metro?
Pull out the pin attaching the kickstart to the variator case of your Honda Metro. You may need to loosen the bolt head of the pin with a socket wrench prior to pulling it. Pulling it will allow you to remove the kickstart from the side of your scooter. Remove the intake case from its position above the variator case.
How do you remove the governor from a Honda Metro scooter?
Wrap the strap around the wheel, tighten it and jam the handle of the wrench underneath the rear pulley wheel. This will give you sufficient leverage to remove the bolt holding the wheel in place without turning the wheel. Unscrew and remove the bolt holding the front pulley wheel in place. Pull the governing washer off of the front pulley rod.
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.
How do you take the kickstand off a Honda Metropolitan?
Take your Metropolitan’s kickstand off. The kickstand is secured with a small pin that must be loosened with a socket wrench before you can pull it out and remove the kickstand. Unscrew the six bolts holding the metal lid of your variator case in place and take the lid off of your scooter.
How do you remove Kickstart from Honda Metro scooter?
Pulling it will allow you to remove the kickstart from the side of your scooter. Remove the intake case from its position above the variator case. The intake case is held in place by three bolts that can be unscrewed with a standard socket wrench. Removing the case will give you more space to work with the variator system.